Outsunny 840-014V01 10 x 10 Feet Pop Up Canopy Tent Gazebo Instruction Manual

: September 12, 2024
: Outsunny

Table of Contents

Outsunny 840-014V01 10 x 10 Feet Pop Up Canopy Tent Gazebo
Product Specifications
Product Usage Instructions
PART LIST
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Outsunny 840-014V01 10 x 10 Feet Pop Up Canopy Tent Gazebo

Product Specifications

Model: IN221200424V02_GL
Version: IN221200424V01_GL_840-014V01
Language: English (EN)
Country: United States/Canada (US_CA)

Product Usage Instructions

Installation
Follow the installation steps provided in the manual. Ensure all components are securely connected.
Powering On
Connect the product to a power source and turn it on using the designated power button.
Configuration
Adjust the settings according to your preferences by navigating through the menu options.
Operation
Use the product as intended for its specific functions. Refer to the manual for detailed operational instructions.

Maintenance
Regularly clean the product using a soft, dry cloth. Avoid using harsh chemicals that may damage the product.

Frequently Asked Questions (FAQ)
Q: How do I reset the product to factory settings?
A: To reset the product to factory settings, locate the reset button on the device and hold it down for 10 seconds.

IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY.

WARNING

Find a flat and stable surface large enough to set up the folding pavilion. Carefully take the tent frame out of the bag and place it on a dry surface (sand, grass or firm surface).
Follow these instructions carefully to avoid getting your hands and fingers caught in the moving parts of the frame when opening and closing the frame. You need at least two people to safely assemble and dismantle the folding pavilion. Do not try to set up the tent by yourself, as pulling on one side can overload the tent legs and damage them unnecessarily. To avoid damage, the tent must be pulled out in tandem.
In windy conditions, secure the tent using the ropes attached to each side of the canopy. Attach the ropes to the pegs at a 30 degree angle and anchor them to the ground with a hammer. If the canopy is placed on a hard surface, secure the 4 sides with bricks or sandbags.
Do not set up the pavilion in windy weather conditions. This can lead to injuries and/ or damage to your tent.
Do not use chemical additives to clean the roofs and side walls. The water temperature can be a maximum of 30°C.
Make sure that you pack the folding tent dry and store it upright in the bag provided in a dry place. A damp tent can get mold stains.
No liability is accepted for damage caused by improper storage or cleaning.
Please take appropriate actions as heavy rain, wind and snow can damage the tent. If necessary please dis -assemble and store for later use.
In snowy conditions please do not allow the thickness of the snow to be more than 5cm on the roof, this should be cleared as soon as possible foryour safety.

PART LIST

STEP -Attach roof canopy (image 2).
- Lay the roof canopy over the frame.
- Position each corner of the roof canopy at the top of each frame pole.
STEP Secure roof canopy (image 3). Secure each corner of the roof canopy to the top of each frame pole using the fastening tabs.
- Ensure roof canopy completely covers all sides of the roof frame.
STEP -Extend and lock roof frame (image 4) & (image 5). Position one hand below the roof frame. Standing at opposite corners, pull out roof frame to extend fully.
- At the same time, push up roof frame with other hand until it ‘clicks’ into the locked position.
- Repeat at all four corners.
- Climb under the roof canopy and secure the fastening tabs to the underside of the roof canopy to the internal cross bars of the roof frame.
STEP – Extend poles (image 6).
- Standing at opposite corners on the pole base, pull up the roof frame by holding the lower section of the pole.
- Pull up the roof frame until the pole ‘clicks’ into the right height position.
STEP – Fitting net wall (image 7)
- Connect the net wall with beam pole by Nylon buckle Be sure the zipper door in mid and at opposite side.
STEP- Secure gazebo (image 8).
- Secure the gazebo by driving 1*tent peg through the hole on each of the poles bases.
- Tie one end of the guy rope to each corner of the roof canopy using the tabs provided
- Secure the other end of the guy rope to the ground using 1*tent peg.
- Using the plastic runner provided, tighten the guy rope to secure your gazebo firmly to the ground.