Outsunny 845-533 Aluminum Polycarbonate Greenhouse Instruction Manual
- October 30, 2023
- Outsunny
Table of Contents
INbxb008V02_GL
845-533
READ AND SAVE THIS INSTRUCTIONS FOR FUTURE USE
Tools Recommended
ASSEMBLY & INSTRUCTION MANUAL
ASSEMBLY PREPARATION
TO PREVENT INJURY, READ AND UNDERSTAND THE GREENHOUSE ASSEMBLY INSTRUCTIONS
BEFORE USE.
Notes:
- It takes about 1-2 hours to assemble the greenhouse by 2-3 persons.
- The UV-protected side of the sheet is covered with opal white film and must face towards the sun.
- Remove approximately 2 inches of film from all sheet edges before installing. Removing all film immediately after the construction is completed
- Make sure the greenhouse is located on a flat, level surface.
GENERAL SAFETY, WARNINGS AND PRECAUTIONS
KEEP WORK AREA CLEAN AND DRY.
Cluttered, damp or wet work areas invite injuries.
STAY ALERT. Watch what you are doing at all times. Use common sense. Do not
use the greenhouse when you are tired or distracted from the job at hand. It
is recommended to use gloves for assembling the greenhouse.
MAINTAIN THIS PRODUCT WITH CARE.
Keep the greenhouse clean and dry for better performance: maintenance
should be performed regularly.
USE THE RIGHT PRODUCT FOR THE JOB.
Do not attempt to force a small product to do the work of a larger
industrial product. There are certain applications for which the greenhouse
was designed. It will do the job better and more safely in the manner for
which it was intended. Do not modify the greenhouse and do not use the
greenhouse for a purpose for which it was not intended.
MAINTAIN A SAFE WORKING ENVIRONMENT.
Keep the work area tidy. Make sure there is adequate Surrounding workspace.
Avoid high traffic areas. Always keep the work area free of obstructions,
grease, oil, trash and other debris.
PROPER GREENHOUSE LOCATION.
Make sure the greenhouse is located on a flat, level surface.
Notes:
- Remove approximately 2 inches of film from all sheet edges before installing. remove all film immediately after the constructions completed.
- The UV-protected side of the sheet is covered with opal white film and must face towards the sun.
Rear
Front
POLYCARBONAE PANEL
Two sides of PC sheet are covered with thin film, one side’s film is transparent, another’s film is opal white. The UV-protected side of the sheet is covered with opal white film and must face towards the sun.
PACKING DETALS TOTAL 2 BOXES
ADVICE
It is not necessary but we would advise: For additional strength, you can also
use some glue : or tapes between the polycarbonate panel and the aluminium
frame to enhance the stability.
Note: Silicone sealant and glue gun are not included in our tool kit. You can
buy them locally. Only use silicone sealant suitable for aluminium
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>