soundcore Q10 Wireless Bluetooth Headphones User Manual
- September 11, 2024
- Soundcore
Table of Contents
soundcore Q10 Wireless Bluetooth Headphones
Charging Your Headphones
| Flashing red once every 30 seconds | Low battery |
|---|---|
| Steady red | Charging (Note: Do not power on Life Q10 while charging) |
| Steady blue | Fully charged |
Powering On / Off
| Power on Press and hold for 3 seconds | Steady blue for 1 second |
|---|---|
| Power off Press and hold for 3 seconds | Steady red for 1 second |
Pairing
Enter Bluetooth pairing mode when Life Q10 is off| Press and hold for 5
seconds
---|---
Enter Multipoint pairing mode| Press and hold for 3 seconds simultaneo
Rapidly flashing blue| Pairing mode
Steady blue| Connected to a device
Note
- Once entered in multipoint pairing mode, you can manually connect a second mobile device to your Soundcore Life Q10.
- Soundcore Life Q10 can only play music on one mobile device at a time.
- Each time you power on your Soundcore Life Q10, it will automatically connect to your last successfully connected device if available.
Controls
Play / pause | Press
Next track | Press and hold for 1 second
Previous track | Press and hold for 1 second
Volume up / down | Press
Bass UP™ Mode (Dual Equalizer) | Press
Answer / End a call| Press
Put the current call on hold and answer a new Press incoming call| Press and
hold for 1 second
Activate Siri or other voice assistant software| 
Press and hold for 1 second
AUX-in
Plugging in an audio cable will automatically switch to AUX mode, and Bluetooth mode will turn off.
Specifications
Specifications are subject
to change without notice.
| Input | 5 V 0.65 A |
|---|---|
| Charging time | 2 hours |
| Playtime | 60 hours |
| Impedance | 16 Ω |
| Driver size | 40 mm × 2 |
| Frequency response | 16 Hz – 40 kHz |
| Bluetooth version | V5.0 |
| Bluetooth range | 15 m / 49.5 f |
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>