dreamer MW1047H 2024 New 10 1 inch Tablet User Guide

September 5, 2024
dreamer

**dreamer MW1047H 2024 New 10 1 inch Tablet User Guide

**

Service Policy

Adreamer products are supplied to consumers who purchase them in strict accordance with the Regulations on Liability for the Repair and Return of Microcomputer Goods.

Battery and storage instructions

  1. Battery life varies depending on individual usage habits.
  2. The usage time varies depending on screen brightness and software operation.
  3. The industry standard definitions for operating memory and storage are as follows.

1GB=1000MB=10001000KB = 10001000*1000B

Windows/Android systems define storage as follows

1GB=1024MB=10241024KB=10241024*1024B TF Type-C

Warning

  1. Replacing a battery with an incorrect model not manufactured by the original manufacturer may result in an explosion hazard.
  2. Consumers should use and purchase original power adapters as standard, and avoid using power adapters that are not certified and do not meet the specifications and standards required.
  3. When products are left unused for a long period of time, pay attention to changes in power level and recharge the product regularly to avoid damage to the battery from over discharge.

About the device

Specifications

CPU Al!winner A523
RAM+ROM 3GB+32GB
BT 4.2
GPS No
WiFi 2.4GHz
TF-card Yes
Display 10.1″ 1280’800
Touch 10-points capacitive touch screen
Battery 6000mAh
MIC Yes
Speaker Yes
G-sensor Yes
OS Android”‘ 13
Camera Front 2MP+Rear 5MP
SIM-card No
Network Yes
Battery life Standby Local 1080P video playback: 8 hours. Note: This is

laboratory test data. The actual battery life will vary slightly depending on the environment and source used by the customer.

Notice: All the pictures in this manual are for reference only. Specifications and design can change without notice. Part of the stated storage is used by the system, so usable storage is smaller. Android is a trademark of Google LLC.

Environmental protection claims

Hazardous Substances Table

Part Name| board| Display| Plastic| Metal| Battery| Accessory
---|---|---|---|---|---|---
Plumbum (Pb)| °| 0| 0| 0| 0| 0
Mercury (Hg)| 0| 0| 0| 0| 0| 0
Cadmium (Cd)| 0| 0| 0| 0| 0| 0
Hexavalent chromiun (Cr6+)| 0| 0| 0| 0| 0| 0
Polybrominated biphenys (PBB)| 0| 0| 0| 0| 0| 0
Polybrominated biphenyls(PBDE)| 0| 0| 0| 0| 0| 0
Butyl Benzyl PhthalatOBP)| 0| 0| 0| 0| 0| 0
Dibutyl Phthalate(DBP)| 0| 0| 0| 0| 0| 0
Diisobutyl Phthalate(DIBP)| 0| 0| 0| 0| 0| 0
Diet hylhexyl Phthalate (DEHP)| 0| 0| 0| 0| 0| 0
Environment Friendly Use Period(EFUP)| 10| 10| 10| 10| 5| 5

o: Indicates that this hazardous substance contained in all homogenous materials of this part is below the limit requirements GB/T 26572-2011

Use period is valid only when the product is operated under the condition defined in the product manual.

Warranty Card

Product Model Number/Name:
Date of Purchase:
Where Purchased:
Your Name:
Address:

Thank you sincerely for choosing Adreamer products

We hereby guarantee and warrant all products owned, for the period time the product in possession of the owner Adreamer Limited will repair and replace defective component which will be no additional charge to the product owner.

If you have any question, feel free to contact us

Email: service@adreamertech.com

No free warranty will be given in the following cases

  1. No valid proof of purchase or three-pack certificate.
  2. Physical damage to the housing LCD caused by  man-made causes is not covered by the free repair.
  3. Drops, crushing, water immersion, moisture and other human-induced damage.
  4. Damage caused by natural disasters such as floods, fires and lightning strikes.

FCC STATEMENT

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement.

Specific Absorption Rate (SAR) information:

This Tablet PC meets the government’s requirements for exposure to radio waves. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies.

The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health. FCC RF Exposure Information and Statement the SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types: Tablet PC has also been tested against this SAR limit. This device was tested for typical body-worn operations with the back of the Tablet PC kept 0mm from the body. To maintain compliance with FCC RF exposure requirements, use accessories that maintain an 0mm separation distance between the user’s body and the back of the phone. The use of belt clips, holsters and similar accessories should not contain metallic components in its assembly.

The use of accessories that do not satisfy these requirements may not comply with FCC RF exposure requirements, and should be avoided.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals