Vantiva G95BGW620 Wi-Fi 7 Gateway Instructions
- September 5, 2024
- Vantiva
Table of Contents
Vantiva G95BGW620 Wi-Fi 7 Gateway
Important Safety Instructions
- The model number, serial number and electrical rating are on the product label.
- This device is for indoor use only, do not place or locate in an outdoor location.
- Use only the power supply and cord provided with the device. Do not use the power supply with any other devices.
- Place the device in a vertical orientation on flat, firm, solid surface, away from any other items.
- Do not locate or use the device near water and avoid areas with moisture.
- Do not locate the device in direct sunlight or near a heat source.
- Do not use any telephone connected to this device to report a gas leak in the vicinity of the leak.
- Do not block the ventilation openings on this device or place in an enclosed location that could cause the device to overheat.
- Never insert objects into the ventilation openings of this device as this can result in the risk of electrical shock or fire.
- Unplug this device before cleaning. Do not use liquids, aerosols, or forced air to clean the device. Clean using a dry, lint-free cloth.
- Use the product in the environment specified as below:
Air temperature between 0°C (32 F) and +40°C (104 F). Relative humidity between 20% and 90%.
Class 1 Laser Product
CAUTION: Viewing the laser output with certain optical instruments (e.g., eye loupes, magnifiers, and microscopes) within a distance of 100 mm (approx. 4 in.) may pose an eye hazard. There must be a proper termination of all active fibers in the network. Complies with 21 CFR 1040.10 and 1040.11, except for conformance with IEC 60825-1 Ed. 3, as described in Laser Notice No. 56, dated May 8, 2019. Only Laser Class 1 Optical Transceiver can be used.
Federal Communications Commission (FCC) Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference
- This device must accept any interference received, including interference that may cause undesired operation.
FCC Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this device.
FCC Radiation Exposure Statement
This device complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter. This device should be
installed and operated with a minimum distance of 21 in. (53 cm) from the
radiating element and any person.
Per FCC regulation, all Wi-Fi devices marketed in US must fix to US operation channels only. The country code selection is for non-US models only and is not available for US models.
FCC regulations restrict the operation of this device to indoor use only.
The operation of this device is prohibited on oil platforms, cars, trains, boats, and aircraft, except that operation of this device is permitted in large aircraft while flying above 10,000 feet in the 5.925-6.425 GHz band.
Operation of transmitters in the 5.925-7.125 GHz band is prohibited for control of or communications with unmanned aircraft systems.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>