Bradley 234-000000 Towel Dispenser And Waste Bin Combo Installation Guide
- June 4, 2024
- Bradley
Table of Contents
Bradley 234-000000 Towel Dispenser And Waste Bin Combo
Product Information
Specifications
- Model: 234
- Product Type: Towel Dispenser/Waste Receptacle
- Installation: Surface-Mounted Unit
- Manufacturer: COMMERCIAL SUPPLY
- Contact Information: BERLS.COM | TEL. 800.BRADLEY (272.3539)
Product Usage Instructions
Installation
- Coordinate installation with architect and contractor to avoid protrusion from opposite wall, pipes vent, conduits, electrical wiring, etc., in the wall. Follow all applicable local building codes.
- If installing where the unit projects above the top of wainscot, provide aluminum channel or other filler to prevent a gap from the finished wall and flange of the unit.
- For block walls, use metal expansion shields (not included).
- Use suitable wall anchors (not included).
- If necessary, shim at anchor points to prevent distortion of the unit.
Rough-in Opening Dimensions:
- Top of Rough Wall Opening to Finished Floor:
- 48″ (1219 mm)
- 45″ (1143 mm)
- 42″ (1067 mm)
- 40″ (1016 mm)
- Bottom of Rough Wall Opening:
- 12″ (305 mm)
- 9″ (229 mm)
- 6″ (152 mm)
- 4″ (102 mm)
FAQ
-
Q: Are wall anchors included with the product?
A: No, suitable wall anchors are not included with the product. Please ensure you have the necessary anchors for installation. -
Q: What should I do if the unit projects above the top of wainscot during installation?
A: Provide aluminum channel or another filler to prevent a gap between the finished wall and the flange of the unit.
Installation
Model 234
Towel Dispenser/Waste Receptacle
P20-138 Rev. C; ECM 11-15-025 © 2012 Bradley Corporation Page 1 of 6 1/26/2012
P.O. Box 309, Menomonee Falls, WI 53052-0309 TEL. 800.BRADLEY (272.3539) FAX
262.251.5817 bradleycorp.com
Coordinate installation with architect and contractor to avoid protrusion from opposite wall, pipes vent, conduits, electrical wiring etc. in wall. Follow all applicable local building codes. If installing where unit projects above top of wainscot, provide aluminum channel or other filler to prevent gap from finished wall and flange of unit. For block walls, use metal expansion shields (not included).
Recessed and Semi-Recessed Dispenser/Waste Receptacle
Dim. “A” Key Surface:| For Dim. “A”| Top of Rough Wall Opening|
Bottom of Rough Wall Opening
---|---|---|---
Paper towel top of opening to finished floor| 48″ (1219)| 66¾” (1695)| 12″
(305)
45″ (1143)| 63¾” (1619)| 9″ (229)
42″ (1067)| 60¾” (1543)| 6″ (152)
40″ (1016)| 58¾” (1492)| 4″ (102)
Bradley Corporation • P20-138 Rev. C; ECM 11-15-025