Liner Master CT000341 Dodge Ram Seat Cover Installation Guide

Table of Contents

Pre-installation Adjustments

Ensure the backrest is reclined to make it easier for the seat covers to slide onto the original seats. [Figure 1]
Remove the all headrests.

Installing the Front Seat Backrest and Bottom Cover

Verify driver and passenger seat covers based on foam tube orientation towards the car door. [Figure 1]
Apply backrest cover to the original car seat backrest. [Figure 21
Thread the securing disc horizontally through the seat gap and adjust it with your fingers. [Figure 3]
Pull the two zippers on the top of the backrest cover outward. [Figure 4]
Insert the headrest pole into the designated slot, cover it with the headrest cover, and secure the inner back fabric with the Velcro. [Figure 5]
Pull both side zippers inward and aattach the center Velcro tabs to adhere to the fuzzy surface inside the back of the headrest cover. [Figure 6]
Hang this at a place under the car where it can be secured, avoiding contact with wires as much as possible. [Figure 7]
Use the plastic shovel to tuck the cushion cover’s edges and foam tubes into the gaps of the original car’s plastic seat. [Figure 8]

Installing the Front Armrest Cover

Lift the first layer of the center console armrest.
Fit the center console armrest cover into the car’s center console armrest. [Figure 11

Installing the Right Rear Long Seat Cover (Backrest)

Confirm the backrest covers on each side by checking the elongated stripe pattern near the side door direction. [Figure 1]
Thread the buckle at the headrest through the middle of the two headrest rods, fastening it with the buckle head above the headrest cover. [Figure 2]
Thread the two disks beneath the backrest cover through the gap, then vertically secure them in place.
Align the center backrest cover with the original car’s backrest area for coverage. [Figure 3]
Secure the foam tube at the headrest by using a plastic shovel to insert it into the gaps on the backside of the original car and the center headrest. [Figure 4]
Thread the securing disk horizontally through the seat gap and adjust it with your fingers for stability.
Peel off the Velcro seals of middle backrest cover on both sides.
Securely attach the fuzzy surface on the back of the right backrest cover to the Velcro on the middle backrest cover. [Figure 5]

Installing the Right Rear Long Cushion Cover (Bottom)

Lay the long seat cushion cover over the right-side cushion, and thread the strap with the fastener head through the seat gap. [Figure 1)
Arrange the seat cushion cover and lift the original car seat. [Figure 21
Thread the buckle head through the loops of the elastic band, align it with the corresponding buckle slot below, and fasten. (Repeat the same on the other side). [Figure 3]
After finishing the Rear Large Bottom and return the large rear bottom seat to its original position.

Installing the Left Rear Short Seat Cover

Install the left rear backrest cover in the same manner.
Place the short seat cushion cover on the left rear seat, and thread the strap with the fastener head through the seat gap. [Figure 1]
Arrange the seat cushion cover and lift the original car seat. [Figure 2]
Thread the buckle head through the loops of 2 elastic bands and fasten it into the buckle slots beneath the seat cushion cover. [Figure 3]
After finishing the Rear small bottom and return the small rear bottom seat to its original position.
If you have any questions or encounter any issues with the product, please don’t hesitate to contact us through Amazon email.
Upon receiving the package, please check the accessories thoroughly. If you find any missing accessories or damage caused during shipping, please contact us directly.

Read User Manual Online (PDF format)