SOLTECH Smart Solar Lighting Remote Control Instruction Manual
- September 3, 2024
- SOLTECH
Table of Contents
Smart Solar Lighting Remote Control
Instruction Manual
Remote Control Guide
The range of the remote control to the indicator is 16ft (Day time) to 33ft (Night time), Because the sunlight will impact the signal of the remote control, we suggest our users to setup the mode before they install the light.
-
On/Off
When off is selected, the light will stop working. The solar panel will not charge the battery and the battery will not supply electricity to the light. -
Connect/Test
Remote control device can be connected with any lighting fixture, When all cables are connected and solar panel detectes sunlight, the fixture will automatically turn on. To test, press the “Test” button once, the LED light will turn on to indicate the fixture has been turned on, During the day time, the indicator will slowly flashing red. That means the battery is charging. -
40%-~100% Motion Sensor Mode
Constant 40% brightness (turns on at dusk, turns off at dawn); 100% brightness turns on for 2 minutes when motion is detected, -
20%~80% Motion Sensor Mode (Default)
Constant 20% brightness (turns on at dusk, turns off at dawn); 80% brightness turns on for 2 minutes when motion is detected, -
Night Owl Mode
Changes as natural light decreases/increases (turns on at dusk); 70% brightness for 0.5 hour, 100% brightness for 3.5 hours, 70% brightness for 1 hour, S0% brightness for 1 hour, 20% brightness for 5 hours (turns off at Dawn), -
Early Bird Mode
Changes as natural light decreases/increases with increased brightness near dawn for early risers (turns on at dusk); 70% brightness for 0.5 hour, 100% brightness for 3.5 hours, 70% brightness for 1 hour, 50% brightness for 1 hour, 20% brightness for 4 hours, 100% brightness for 1 hour (turns off at Dawn). Important
Dusk and dawn time may be diffrent in other locations and seasons.
The sensors of our products will follow the light patterns of where it is installed. The time period shown in the chart above is just an example to help you understand the different lighting modes only. -
100% Constant Mode
100% brightness from dusk to dawn. -
70% Constant Mode
70% brightness from dusk to dawn. -
40% Constant Mode
40% brightness from dusk to dawn, -
Timer Mode Disabled
Press this button to turn off Timer Mode; settings revert back to before Timer Mode was last activated. -
Timer Mode Disabled
Press this button to turn off Timer Mode; settings revert back to before Timer Mode was last activated. -
Timer Mode 4 Hours
This is an additional mode which can work with any other modes. For example: press this button at any time after you turn on 70% Constant Mode. If the light turns on at 7pm at dusk, it will turn off at 11pm. It will repeat the same schedule hereafter until it is canceled by pressing Timer Mode Disabled. -
Time Mode 8 Hours
This is an additional mode which can work with any other modes. For example: press this button at any time after you turn on 70% Constant Mode. If the light turns on at 7pm at dusk, it will turn off at 3am. It will repeat the same schedule hereafter until it is canceled by pressing Timer Mode Disabled.
Important
Dusk and dawn time can vary for different locations and seasons. The sensors
in our products will monitor the light levels where it is installed. The time
period shown in the chart above is just an example to help you understand the
different lighting modes.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>