Anhui BBM-001-RC Remote Control of Bubble Bath Massager User Manual
- August 31, 2024
- Anhui
Table of Contents
BBM-001-RC Remote Control of Bubble Bath Massager
“`html
Product Specifications:
- Transmission Frequency: 433.92MHz
- Battery Model: 3V button lithium battery
Product Usage Instructions:
-
Upshift Button: Press to increase the power of
wave making. Each press increases the power and decreases the
amount of bubbles produced. -
Downshift Button: Press to reduce the power of
wave making. Each press reduces the power and decreases the amount
of bubbles produced. -
Heating Button: Press to turn on the main
heating light and activate the heating function. -
On/OFF Button: Press to turn on wave mode,
then press again to turn off.
FAQ (Frequently Asked Questions):
Q: How do I change the battery in the remote control?
A: To change the battery, locate the battery compartment on the
remote control, remove the old battery, and insert a new 3V button
lithium battery in the correct orientation.
Q: What should I do if the remote control stops working?
A: Check if the battery needs replacement. If the battery is
fine, try re-pairing the remote control with the device according
to the pairing instructions in the user manual.
Q: How do I know if the heating function is active?
A: When you press the Heating Button, the main heating light
will turn on, indicating that the heating function is
activated.
“`
Remote Control Manual
Downshift Upshift Heating On/Off
Remote control Technical parameters of remote control
1. Transmission frequency: 433.92MHz 2. Battery model: 3V button lithium
battery Operation Instructions of Remote Control 1. Upsh ift But ton : Incr ea
se the po wer of wave maki ng . Each pr ess incr ea ses the po wer
an d the am ou nt of bu bb les pr od uce d de cr ea ses . 2. Dow nsh ift But
ton : Red uce the po wer of wave maki ng . Each pr ess red uce s the po wer
an d the am ou nt of bu bb les pr od uce d de cr ea ses . 3. Heating Button:
Press the heating key to turn on the main heating light and activate the
heating function. 4. On/OFF: Press to turn on wave mode, then press to turn
off.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures: — Reorient or relocate the receiving antenna. —
Increase the separation between the equipment and receiver. — Connect the
equipment into an outlet on a circuit different from that to which the
receiver is connected. — Consult the dealer or an experienced radio/TV
technician for help.
Warning: changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment
The devices has been evaluated to meet general RF exposure requirement the
device can be used in portable exposure condition without restriction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>