Novsight Rock Series 12 Inch Single Row LED Off Road Light Bar High Power Installation Guide
- August 30, 2024
- NOVSIGHT
Table of Contents
Novsight Rock Series 12 Inch Single Row LED Off Road Light Bar High Power
SPECIFICATIONS
Voltage: 9-36V DC
Beam Pattern: Driving Beam| Optional Length: 10″, 13.5″, 20″, 30″, 40″
and 50″
What’s Included: 1 X Light Bar Side and Bottom Mount Brackets &
Hardware
Dimensions
- Length: 501mm (19.72 inches)
- Width: 41.5mm (1.63 inches)
- Height: 19.2mm (0.76 inches)
- Mounting Depth: 71mm (2.80 inches)
- Total Height with Mounting Brackets: 545mm (21.46 inches)
MOUNTING INSTALL INSTRUCTION
Side Mounts
Bottom Mounts
INSTALL INSTRUCTION
For One 13.5″, 20″, 30″, 40″ or 50″ Light Bar
( Tips: 50″ light bar uses 10 AWG one-output wiring harness, other sizes use 14 AWG one)
- Determine the appropriate mounting locations to install the LED light bar, wiring harness, and switch. Once all mounting locations are confirmed, connect the wires as shown above. Proper insulation at connections is required.
- Connect positive wire and negative wire properly. Press the switch to test if the light is working properly.
- Adjust the light to the desired angle and then secure by tightening all mounting screws.
FAQs
- Q: What is the voltage range for this product?
- A: The voltage range is 9-36V DC.
- Q: Can I use a different wiring harness for a 50″ light bar?
- A: Yes, for a 50″ light bar, it is recommended to use a 10 AWG one-output wiring harness. Other sizes should use a 14 AWG one.
- Q: How do I test if the light bar is working properly?
- A: Connect the positive and negative wires correctly, then press the switch to test the functionality of the light.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>