RETEKESS TH009 Waterproof Single Key Call Button Instruction Manual

August 28, 2024
RETEKESS

RETEKESS TH009 Waterproof Single Key Call Button

Specifications:

  • Size: 67.5mm x 14.5mm (H)
  • Material: ABS
  • Communication: 433.92MHz (OOK) mode
  • Battery: 23A 12V battery * 1pc inside
  • Work Current: 28mA
  • Power: 10mW MAX
  • Communication Distance: 800m open distance

Product Function Introduction
Before leaving the factory, the battery is already installed inside the product. After unpacking and pairing with the host, follow these steps to use the product:

  1. Press the Call button on the product to call the host (ensure prior pairing of the extension and host for the call function).
  2. The indicator light on the product will briefly turn red when the call is initiated.
  3. Attention: If the battery is low, the indicator light will flash red until the battery is depleted. Promptly replace the battery.

Product diagram

Item Description Remark
1 indicator lamp When calling the host, there is a light display

here;

2| Call button| You need to press this key to call the host

Product characteristic parameter

Item Category Description Remark
1 Size Φ67.5mm-14.5(H)
2 Material ABS
3 Communication

mode

| 433.92MHz(OOK)|
4| Battery| 23A12V battery*1pcs(inside)| It can support 6000

calls

5| Work Current| 28mA|
6| Power| 10mW MAX|
7| Communication

Distance

| 800m(open distance)|

Product Function Introduction

Before leaving the factory, the battery has already been installed inside the product, and after unpacking and pairing with the host, the product can be used normally.

Call the host: Press the Call button on the product to complete the call to the host (pairing of the extension and the host needs to be completed in advance to achieve the call function); At the same time, the indicator light on the product will briefly turn red;

Attention : When the battery is low, the product indicator light will continue to flash red until the battery is depleted and will no longer flash. Please remind users to replace the battery in a timely manner.

RF ENERGY EXPOSURE AND PRODUCT SAFETY GUIDE

ATTENTION! Before using this radio, read this guide which contains important operating instructions for safe usage and RF energy awareness and control for compliance with applicable standards and regulations.

This radio uses electromagnetic energy in the radio frequency (RF) spectrum to provide communications between two or more users over a distance. RF energy, which when used improperly, can cause biological damage. All Retekess radios are designed, manufactured, and tested to ensure they meet government- established RF exposure levels. In addition, manufacturers also recommend specific operating instructions to users of the radios. These instructions are important because they inform users about RF energy exposure and provide simple procedures on how to control it.

Please refer to the following websites for more information on what RF energy exposure is and how to control your exposure to assure compliance with established RF exposure limits: http://www.who.int/en/

Local Government Regulations
When radios are used as a consequence of employment, the Local Government Regulations requires users to be fully aware of and able to control their exposure to meet occupational requirements. Exposure awareness can be facilitated by the use of a product label directing users to specific user awareness information. Your Retekess radio has a RF Exposure Product Label. Also, your Retekess user manual, or separate safety booklet includes information and operating instructions required to control your RF exposure and to satisfy compliance requirements.

Unauthorized modification and adjustment
Changes or modifications not expressly approved by the party responsible for compliance may void the user’s authority granted by the local government radio management departments to operate this radio and should not be made. To comply with the corresponding requirements, transmitter adjustments should be made only by or under the supervision of a person certified as technically qualified to perform transmitter maintenance and repairs in the private land mobile and fixed services as certified by an organization representative of the user of those services. Replacement of any transmitter component (crystal, semiconductor, etc.) not authorized by the local government radio management departments equipment authorization for this radio could violate the rules.

FCC Requirements

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. this device must accept any interference received, including interference that may cause undesired operation.

(If applicable) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not  installed and used in accordance with the instructions, may cause harmful interference toradio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

CE Requirements:
(Simple EU declaration of conformity) Henan Eshow Electronic Commerce Co.,Ltd
declares that the radio equipment type is in compliance with the essential requirements and other relevant provisions of RED Directive 2014/53/EU and the ROHS Directive 2011/65/EU and the WEEE Directive 2012/19/EU; the full text of the EU declaration of conformity is available at the following internet address: www.retekess.com.

Disposal
The crossed-out wheeled bin symbol on your product, literature, or packaging reminds you that in the European Union, all electrical and electronic products, batteries, and accumulators (rechargeable batteries) must be taken to designated collection locations at the end of their working life. Do not dispose of these products as unsorted municipal waste. Dispose of them according to the laws in your area.

RF Exposure Information (if appropriate)
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Protect your hearing:
Note : Exposure to loud noises from any source for extended periods of time may temporarily or permanently affect your hearing. The louder the radio’s volume, the less time is required before your hearing could be affected. Hearing damage from loud noise is sometimes undetectable at first and can have a cumulative effect.

Approved Accessories

  • This radio meets the RF exposure guidelines when used with the Retekess accessories supplied or designated for the product. Use of other accessories may not ensure compliance with the RF exposure guidelines and may violate regulations.
  • For a list of Retekess-approved accessories for your radio model, visit the following website: http://www.Retekess.com

Guarantee

  • Model:
  • Number:
  • Serial Number:
  • Purchasing Date:
  • Dealer: Telephone:
  • User’s Name: Telephone:
  • Country: Address:
  • Post Code: Email:

Remarks:

  1. This guarantee card should be kept by the user, no replacement if lost.
  2. Most new products carry a two-year manufacturer’s warranty from the date of purchase.
  3. The user can get warranty and after-sales service as below:
    • Contact the seller where you buy.
    • Products Repaired by Our Local Repair Center
  4. For warranty service, you will need to provide a receipt proof of purchase from the actual sellerfor verification

Exclusions from Warranty Coverage:

  1. To any product damaged by accident.
  2. In the event of misuse or abuse of the product or as a result of unauthorized alterations or repairs.
  3. If the serial number has been altered, defaced, or removed.

Henan Eshow Electronic Commerce Co., Ltd
Add: 7/F, Sanjiang Building, No.170 Nanyang Road, Huiji District, Zhengzhou, Henan, China

  • EU Importer: Germany Retevis Technology GmbH
  • Address: Uetzenacker 29,38176 wendeburg
  • Facebook: facebook.com/RetekessWirelessSystem
  • E-mail: support@retekess.com
  • Web: www.retekess.com

MADE IN CHINA

FAQ

Q: How do I know when to replace the battery?
A: The indicator light will flash red continuously when the battery is low. Please replace the battery promptly.

Q: Can I use this product without pairing with the host?
A: No, pairing with the host is necessary to enable the calling function. Make sure to complete the pairing process before use.

Q: What should I do if I encounter issues with the product?
A: For warranty and after-sales service, contact the seller where you made the purchase or reach out to our local repair center for assistance.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals