ROLLER Easy-Press Manual Radial Press up to 26 mm Instruction Manual
- August 22, 2024
- ROLLER
Table of Contents
ROLLER Easy-Press Manual Radial Press up to 26 mm Instruction Manual
PRODUCT OVERVIEW
Translation of the Original Instruction Manual
The respective latest sales literature applies for the use of ROLLER’S
pressing tongs, ROLLER’S S (PR-2B) pressing rings with Z8 adapter tongs,
driven by ROLLER’S Easy-Press, for the different pipe connection systems, see
also www.albert-roller.
de → Downloads → Product Catalogues, Brochures. If the system manufacturer
alters components of pipe connection systems or markets new ones, their
current application status must be enquired about at ROLLER (e-mail info@
albert- roller.
de). Subject to change and error.
ROLLER’S Easy-Press is intended for making press joints with plastic and composite pipes Ø10–40 mm, Ø ⅜–1″ of common press fitting systems. All other uses are not for the intended purpose and are therefore prohibited. All ROLLER’S pressing tongs/ adapter tongs Z8 with plug-in borings at the end of the pressing jaws are suited for operating with the ROLLER’S Easy-Press drive unit. The length of the drive unitlever can be adjusted on site according to pressing force and space. Use only the supplied pipe arms with sockets for extension. Further lengthening of the pipe arms is not permitted. This increases the risk of material damage and injuries. Tighten pipe arms securely before use (danger of accident!).
Using with pressing tongs (Fig. 1): Set the drive unit to a gap of approx. 25 mm at “C” to insert/change the pressing tongs. Insert the selected pressing tongs into the drive unit and secure with plug-in bolts. Open the pipe arms until the pressing tongs can be pushed over the press connector. Press together the pipe arms up to the end stop at “C”. A perfect press joint is only produced after complete closure of the pressing tongs at “A”.
Using the S (PR-2B) pressing ring with Z8 adapter tongs (Fig. 2): Set the
drive unit to a gap of approx. 25 mm at “C” to insert the adapter tongs.
Insert the adapter tongs into the drive unit and secure with plug-in bolts.
Lay the S (PR-2B) pressing ring around the press connector. Open the pipe arms
until the hemispheres of the Z8 adapter tongs can be applied to the ball
sockets of the S (PR-2B) pressing ring.
Close the pipe arms so that the hemispheres of the adapter tongs grip and lie
firmly in the ball sockets of the pressing ring. On the S (PR-2B) pressing
ring, the Z8 adapter tongs can be applied swivelled continuously to any angle.
Press together the pipe arms up to the end stop at “C”. A perfect press joint
is only produced after complete closure of the S (PR-2B) pressing ring at “A”.
Have the perfect functioning of the ROLLER’S Easy-Press, ROLLER’S pressing tongs, ROLLER’S S (PR-2B) pressing rings and Z8 adapter tongs checked by ROLLER’S or an authorised ROLLER customer service workshop at least once a year.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>