RealMCU BM-8762CMF Bluetooth 5.0 BLE Module User Guide
- June 3, 2024
- RealMCU
Table of Contents
RealMCU BM-8762CMF Bluetooth 5.0 BLE Module User Guide
Introduction
The BM-8762CMF is an ultra-low-power system on-chip module for Bluetooth 5 low
energy applications that combines the excellent performance of a leading RF
transceiver with a low-power ARM Cortex-M4F and rich powerful supporting
features and peripherals. It combines a BT Protocol Stack for GAP, ATT/GATT,
SMP, L2CAP
FCC ID: PANBM8762CMF
SPECIFICATION
| Product Name | Bluetooth 5.0 BLE Module |
|---|---|
| Model Number | BM-8762CMF |
| Power Supply | 3.3V Supply Voltage |
| Interface | UART |
| Operating Temperature | -20 – 85° C Ambient temperature |
| Frequency Range | 2402~2480 MHz |
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this
equipment.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
Radiation Exposure Statement:
This device is intended only for OEM integrators under the following conditions:
As long as 2 conditions above are met, further transmitter test will not be
required. However, the OEM integrator is still responsible for testing their
end-product for any additional compliance requirements required with this
module installed
IMPORTANT NOTE:
In the event that these conditions can not be met (for example certain laptop
configurations or co-location with another transmitter), then the FCC
authorization is no longer considered valid and the FCC ID can not be used on
the final product. In these circumstances, the OEM integrator will be
responsible for re-evaluating the end product (including the transmitter) and
obtaining a separate FCC authorization.
End Product Labeling
The product can be kept as far as possible from the user body or set the
device to lower output power if such function is available. The final end
product must be labeled in a visible area with the following: “Contains FCC
ID: PANBM8762CMF”. The grantee’s FCC ID can be used only when all FCC
compliance requirements are met.
Manual Information To the End User
The OEM integrator has to be aware not to provide information to the end user
regarding how to install or remove this RF module in the user’s manual of the
end product which integrates this module.
The end user manual shall include all required regulatory information/warning
as show in this manual.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>