HardCabs 2019 Ranger Crew XP 1000 Installation Guide
- August 27, 2024
- hardcabs
Table of Contents
HardCabs 2019 Ranger Crew XP 1000
Specifications
- Product Name: Polaris Ranger Crew XP 1000
- Model Year: 2019
- Manufacturer: HardCabs/DFK America
- Contact Information: 2464 Wisconsin Avenue, Downers Grove, IL 60515 | 630-324-8585 | parts@hardcabs.com
Installation Instructions
Before starting the assembly process, make sure to read the complete assembly instructions thoroughly. Failure to follow the instructions can result in personal injury.
- Install all parts as indicated in the assembly instructions.
- Assembly of the product requires the use of hand or power tools. If you are not experienced in using these tools, it is recommended to have the product dealer perform the installation.
- Wear protective gloves if necessary due to sharp edges on some parts. Keep the assembly area clean, uncluttered, and well lit.
- Keep visitors and children at a safe distance from the assembly area. Visitors should also wear appropriate safety equipment.
Maintenance and Cleaning
- To clean the polycarbonate surface, use a soapy water solution or other gentle means.
- Dirt and dust can be washed away by gently streaming water and wiping only with wet or damp materials from top to bottom.
- The recommended cleaning frequency for polycarbonate parts is about once per month or according to the degree of pollution.
- Do not use detergents that may scratch the surface plates, such as abrasives or harsh fabrics.
- Avoid using solvents, alkaline detergents, or cleaners with ammonia on the surface.
Electro installation Heater
- Connect the pulse bar with the original ground screw.
- Remove the original cable grommet from the dashboard hole. Cut a hole in the grommet for the wiper, washer, and heater harness.
- Remove all dashboard fixing plastic cover push pin rivets.
- Tilt the steering wheel to the full down position. Detach the instrument cluster hood by removing two push pin rivets, then slide the hood (and instrument cluster) rearward. Disconnect the instrument cluster wiring harness.
FAQs
Q: What should I do if I encounter scratches on the polycarbonate
surface?
A: If scratches occur, contact the manufacturer for recommendations on proper
repair methods to avoid further damage.
Q: How often should I check and tighten bolted connections on the cab?
A: It is recommended to check and tighten bolted connections regularly to
ensure safe usage of the product. Follow the user manual guidelines for
specific intervals.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>