TIMEX 076-095000-03 Men Street Sport Watch User Guide

: August 20, 2024
: Timex

Table of Contents

TIMEX 076-095000-03 Men Street Sport Watch
FEATURES AND BASIC OPERATION
TIME
CHRONOGRAPH
WATER RESISTANCE
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

TIMEX 076-095000-03 Men Street Sport Watch

WARNING

INGESTION HAZARD: This product contains a button cell or coin battery.
DEATH or serious injury can occur if ingested.
A swallowed button cell or coin battery can cause Internal Chemical Burns as Tittle as 2 hours.
KEEP new and used batteries OUT OF REACH of CHILDREN Seek immediate medical attention if a battery is suspected to be swallowed or inserted inside any part of the body.
Remove and immediately recycle or dispose of used batteries according to local regulations and keep them away from children. Do NOT dispose of batteries in household trash or incinerate them.
Even used batteries may cause severe injury or death.
Call a local poison control center for treatment information.
Battery type: lithium metal, CR2032.
Nominal battery voltage: 3.0 V
Non-rechargeable batteries are not to be recharged.
Do not force discharge, recharge, disassemble, heat above 158°F (70°C), or incinerate. Doing so may result in injury due to venting, leakage, or explosion resulting in chemical burns.
Ensure the batteries are installed correctly according to polarity (+ and -).
Do not mix old and new batteries, different brands, or types of batteries, such as alkaline, carbon zinc, or rechargeable batteries.
Remove and immediately recycle or dispose of batteries from equipment not used for an extended period according to local regulations.
Always completely secure the battery compartment. If the battery compartment does not close securely, stop using the product, remove the batteries, and keep them away from children.

THANK YOU FOR PURCHASING YOUR TIMEX® WATCH
Please read the instructions carefully to understand how to operate your Timex® watch.

FEATURES AND BASIC OPERATION

Time with 12- or 24-hour format
Date with MM-DD or DD.MM format
3 time zones
Alerts with audible tone and/or silent vibration
Optional hourly chime
100-hour chronograph with a display of lap and split times
24-hour countdown timer (count down and stop or repeat)
Hydration timer
3 daily/weekday/weekend alarms with a 5-minute backup
Customizable mode set (hide unwanted modes)
INDIGLO® night-light with NIGHT-MODE® feature
Press MODE repeatedly to step through modes: Chrono, Timer, Hydration, Alarm 1, Alarm 2, and Alarm 3.
Press MODE to exit the current mode and return to Time mode.
Button functions are shown with secondary functions in parentheses. Watch displays may vary.
Button operations are the same.

TIME

To set time, date, and options:

With time and date showing, press and hold SET.
Current time zone (2,1, or 3) flashes. Press + or – to select the time zone to set, if desired.
Press NEXT. Hour flashes. Press + or – to change the hour (including AM/PM); hold the button to scan values
Press NEXT. Minutes flash. Press + or – to change minutes
Press NEXT. Seconds flash. Press + or – to set seconds to zero.
Press NEXT. Month flashes. Press + or – to change the month.
Press NEXT. Day flashes. Press + or – to change the day.
Press NEXT. Year flashes. Press + or – to change the year.
Press NEXT to set options. Press + or – to change the value and then press
NEXT to go to the next option. Available options are -12 or -24-hour time format, Month-Day, or Day. Month date format, tone or vibration alert, hourly chime, beep for button presses, customizable mode set (Select “HIDE” for unwanted modes — they are removed from the mode sequence). Press DONE at any step to exit and save settings.

If you hide a mode, you can turn it back on later using the procedure above. Press START·SPLIT once and hold to see 2nd time zone. Press START·SPLIT twice and hold to see the third time zone. Continue to hold the button for 4 seconds to switch to the displayed time zone. Dual mode offers a choice of alert type for alarms and countdown time: audible tone, silent vibration, or a combination of vibrations followed by tone. To set, refer to point 9.

CHRONOGRAPH

This model provides a chronograph (stopwatch) function. Press MODE to go to Chrono mode.
To start, press START·SPLIT. Chrono counts up by hundredths of a second up to one hour, then by seconds up to 100 hours.
The chrono indicator flashes to indicate chrono is running.
To stop, press STOP·RESET. The Chrono indicator is solid to indicate that chrono is stopped.
To resume, press START·SPLIT, or to reset (clear) chrono, press and hold STOP·RESET.
When Chrono is already running, Chrono continues to run if you exit mode. Stopwatch indicator w appears in TIME mode.
While Chrono is running, press START·SPLIT to take a split. Lap and split times will be displayed with the lap number.
To set the display format, press SET. Then, press + or – to select the desired format.
Press DONE to exit.

NOTE
When a split is taken, times are frozen on the display for 10 seconds. Press MODE to release the display and show the running Chrono immediately.

TIMER
Timer mode provides a countdown timer with an alert. Press MODE repeatedly until TIMER appears.

To set the countdown time

Press SET. Hours flash. Press + or – to change hours; hold the button to scan values.
Press NEXT. Minutes flash. Press + or – to change minutes.
Press NEXT. Seconds flash. Press + or – to change seconds.
Press NEXT. Action at the end of the countdown flashes. Press + or – to select STOP or REPEAT.
Press DONE at any step when done setting.

To start the timer, press START·SPLIT. The timer counts down every second from the countdown time. The timer indicator flashes to indicate the timer is running. To pause the countdown, press STOP·RESET. The timer indicator is solid to indicate the timer is stopped. To resume the countdown, press START·SPLIT, or to reset the countdown, press STOP·RESET. Watch beeps and night-light flashes when the countdown ends (timer reaches zero). Press any button to silence. If REPEAT AT END is selected,
the timer repeats the countdown indefinitely. The timer continues to run if you exit mode. The timer indicator is solid in Time mode.

HYDRATION
Hydration mode provides a countdown timer with an alert to remind you to drink during a workout. Press MODE repeatedly until HYDRA appears.

To set hydration time

Press SET. Minutes flash. Press + or – to change minutes; hold the button to scan values.
Press NEXT. Seconds flash. Press + or – to change seconds; hold the button to scan values.
Press DONE at any step when done setting.
To start the hydration timer, press START·SPLIT. The timer counts down every second from the countdown time. The hydration indicator will flash to indicate the timer is running.
To pause the countdown, press STOP·RESET. The hydration indicator will be solid.
To resume the countdown, press START·SPLIT, or to reset the countdown, press STOP·RESET.
Watch beeps and night-light flashes when the countdown ends (timer reaches zero). Press any button to stop the alert.
The hydration timer continues to run if you exit mode. The hydration indicator will be solid in Time mode.

ALARM
The watch has three alarms. Press MODE repeatedly until ALM 1, ALM 2, or ALM 3 appears.

To set alarm

Press SET. Hour flashes. Press + or – to change the hour; hold the button to scan values.
Press NEXT. Minutes flash. Press + or – to change minutes.
Press NEXT. AM/PM flashes if in -12-hour time format. Press + or – to change.
Press NEXT. Alarm day setting flashes. Press + or – to select DAILY, WKDAYS, or WKENDS.
Press DONE at any step when done setting.
To turn the alarm on/off, press START·SPLIT. If the Alarm is set, the Alarm indicator is solid in Time mode.
When the alarm sounds, the night light flashes. Press any button to silence. If no button is pressed, the alarm will sound for 20 seconds and repeat once five minutes later.
Each of the three alarms has a different alert melody.

INDIGLO® NIGHT-LIGHT WITH NIGHT MODE® FEATURE
Press the INDIGLO® button to illuminate the watch display for 3 – 2 seconds (6 – 5 seconds while setting). Electroluminescent technology used in the INDIGLO® night-light illuminates the entire watch face at night and in low light conditions. Any button pressed while the INDIGLO® night light is on keeps it on. Press and hold the INDIGLO® button for 4 seconds to activate the NIGHT- MODE® feature. The moon icon will appear in Time mode. Feature causes any button press to activate INDIGLO® night-light for 3 seconds. NIGHT-MODE® feature may be deactivated by pressing and holding the INDIGLO® button again for 4 seconds, or it automatically deactivates after 8 hours.

WATER RESISTANCE

If your watch is water-resistant, meter marking or ( ) indicates pounds per square inch absolute
WARNING: TO MAINTAIN WATER RESISTANCE, DO NOT PRESS ANY BUTTONS UNDER WATER.

The watch is water-resistant only as long as the lens, push buttons and case remain intact.
The watch is not a diver watch and should not be used for diving.
Rinse the watch with fresh water after exposure to salt water.
Shock resistance will be indicated on the watch face or caseback. Watches are designed to pass the ISO test for shock resistance. However, care should be taken to avoid damaging the crystal/lens.

BATTERY
The watch button cell or coin battery is not intended to be replaced by a consumer. Only a jeweler or other professional is to replace the battery.

TIMEX INTERNATIONAL WARRANTY
www.timex.com/pages/warranty-repair
©2024Timex Group USA, Inc. TIMEX, INDIGLO, and NIGHT-MODE are trademarks of Timex Group B.V. and its subsidiaries.