TIMEX TW5M22600 Combo Watch User Guide

: August 20, 2024
: Timex

Table of Contents

Safety Precaution
FEATURES AND BASIC OPERATION
TIME
STOPWATCH
ALARM
WATER AND SHOCK RESISTANCE
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

TIMEX TW5M22600 Combo Watch

Safety Precaution

WARNING

INGESTION HAZARD: This product contains a button cell or coin battery.
DEATH or serious injury can occur if ingested.
A swallowed button cell or coin battery can cause Internal Chemical Burns in as little as 2 hours.
KEEP new and used batteries OUT OF REACH of CHILDREN
Seek immediate medical attention if a battery is suspected to be swallowed or inserted inside any part of the body.

|

Remove and immediately recycle or dispose of used batteries according to local regulations and keep away from children. Do NOT dispose of batteries in household trash or incinerate.
Even used batteries may cause severe injury or death.
Call a local poison control center for treatment information.
Battery types: lithium metal CR2025 and silver oxide SR626SW.
Nominal battery voltage: 3.0 V and 1.5 V
Non-rechargeable batteries are not to be recharged.
Do not force discharge, recharge, disassemble, heat above 140°F (60ºC) or incinerate. Doing so may result in injury due to venting, leakage or explosion resulting in chemical burns.
Ensure the batteries are installed correctly according to polarity (+ and -).
Do not mix old and new batteries, different brands or types of batteries, such as alkaline, carbon zinc, or rechargeable batteries.
Remove and immediately recycle or dispose of batteries from equipment not used for an extended period of time according to local regulations.
Always completely secure the battery compartment. If the battery compartment does not close securely, stop using the product, remove the batteries, and keep them away from children.

Register your product at https://www.timex.com/product-registration.html

FEATURES AND BASIC OPERATION

Date with MM-DD (month/day) format
Daily Alarm with Snooze feature
Hourly Chime
24-Hour Stopwatch with Split time
INDIGLO® night-light

Button functions shown with setting functions in parentheses.

TIME

To set time and date

To start your watch remove the plastic guard from under the crown, then press the crown in against the case. The second hand will begin advancing in one-second intervals.
Pull the crown out all the way and turn to the correct analog time. Push the crown in to restart the analog watch.Press START or ST/STP/ALM to set Seconds to zero adding one minute if seconds are “30” or greater.
Press RESET or RESET/NEXT to set Hours, as indicated by its flashing.
Press START or ST/STP/ALM to advance the Hours setting. Press and hold to increment quickly.
Note : As the Hours are incremented, the time indicator changes from “A” (AM), to “P” (PM) to “H” (24-hour time)
Press RESET or RESET/NEXT to set Minutes, as indicated by its flashing. Press START or ST/STP/ALM to advance the Minutes setting. Press and hold to increment quickly.
Press RESET or RESET/NEXT to set the Month number, as indicated by its flashing. Press START or ST/STP/ALM to advance the Month setting. Press and hold to increment quickly.
Press RESET or RESET/NEXT to set the Day, as indicated by its flashing. Press START or ST/STP/ALM to advance the Day setting. Press and hold to increment quickly.
Press RESET or RESET/NEXT to set Day of the Week, as indicated by its flashing. Press START or ST/STP/ALM to advance the Day of the Week setting. Press and hold to increment quickly.
Press MODE to exit Time Set.

STOPWATCH

Use this function for timing events.

Press MODE until “ST” appears.
Press START or ST/STP/ALM to start timing.
With the stopwatch running, press RESET or RESET/NEXT to record a Split time. The stopwatch will continue timing in the background.
Press RESET or RESET/NEXT to release the display and show the current running stopwatch time.
Press RESET or RESET/NEXT to record another Split time.
Press START or ST/STP/ALM to pause the timing.
Either press START or ST/STP/ALM to resume timing, or press RESET or RESET/NEXT to reset the Stopwatch to zero.

Note : If the Stopwatch was paused when the display was showing a Split time, the first press of RESET or RESET/NEXT will show the final recorded time, and the second press will reset the Stopwatch to zero.

ALARM

To turn on/off or to set a Daily alarm with a one-time snooze feature. To turn on/off an hourly chime.

Press MODE until “AL” appears.
Press START or ST/STP/ALM repeatedly to turn on/off the Alarm ( ) or the Hourly Chime (SIG or ) or both.
To Set the Alarm, press RESET or RESET/NEXT. The Hour digit flashes and the Alarm ON (ALM or ) lights.
Press START or ST/STP/ALM to advance the Hours setting. Press and hold to increment quickly.
Note : The Hours will be presented in the same format (12- or 24-hour time) as the time setting.
Press RESET or RESET/NEXT to set the Minutes as indicated by its flashing. Press START or ST/STP/ALM to advance the Minutes setting. Press and hold to increment quickly.
Press RESET or RESET/NEXT to exit the Alarm Setting mode.
When the alarm sounds:
- Press START or ST/STP/ALM or RESET or RESET/NEXT to stop the alert, and the alarm will sound at the same time on the next day. OR,
- Press MODE while the alert is sounding. This will stop the alert and postpone the alarm for 5 minutes.

Note : The Alarm ON ( ) will flash to confirm Snooze mode.

INDIGLO® NIGHT-LIGHT

Press INDIGLO® button to illuminate watch display for 2-3 seconds.
Electroluminescent technology used in the INDIGLO® night-light illuminates watch face at night and in low light conditions.

WATER AND SHOCK RESISTANCE

If your watch is water-resistant, meter marking or ( ) is indicated.

Water-Resistance Depth	p.s.i.a. * Water Pressure Below Surface
30m/98ft	60
50m/164ft	86
100m/328ft	160

*pounds per square inch absolute

WARNING : TO MAINTAIN WATER-RESISTANCE, DO NOT PRESS ANY BUTTONS UNDER WATER.

Watch is water-resistant only as long as lens, push buttons and case remain intact.
Watch is not a diver watch and should not be used for diving.
Rinse watch with fresh water after exposure to salt water.
Shock-resistance will be indicated on watch face or caseback. Watches are designed to pass ISO test for shock-resistance. However, care should be taken to avoid damaging crystal/lens.

BATTERY

The watch button cell or coin battery is not intended to be replaced by a consumer. Only a jeweler or other professional is to replace the battery.

TIMEX INTERNATIONAL WARRANTY
https://timex.com/pages/warranty-repair