Leuze electronic DCR 200i Camera Based Code Reader Owner’s Manual
- August 21, 2024
- Leuze electronic
Table of Contents
Leuze electronic DCR 200i Camera Based Code Reader
Product Specifications
- Product: DCR 200i
- Accessories: Housing hoods, diffusor foil
- Options: Housing hoods with plastic or glass screen, diffuser foil for increased scatter of LED illumination
FAQ
- Q: Can the diffusor foil be used with the polarization filter?
- A: No, the diffusor foil is not suitable for use in combination with the polarization filter.
- Q: What should I do before replacing the housing hood?
- A: Make sure there is no voltage in the system, clean the new hood with a soft cloth, and ensure the sealing surface in the housing base is clean.
Introduction
- Housing hoods to be used as a replacement in the event of changed operating conditions or as a replacement for defective or scratched original hood
- Housing hoods with either plastic or glass screen (optionally with polarization filter)
- Diffusor foil for increased scatter of the integrated LED illumination of the code reader
Remarks
Operate in accordance with intended use!
- The product may only be put into operation by competent persons.
- Only use the product in accordance with the intended use.
Replacing the housing hood
Cover DCR 200i…
- Only replace the housing hood while there is no voltage in the system!
- Clean the new hood with a soft cloth before installing.
- Make certain that the sealing surface in the housing base is clean before installing!
- Tightening torque of the fastening screws < 25Ncm!
- Loosen the four fastening screws of the housing hood.
- First tip the housing hood downward and away from the housing.
- Next lift the housing hood upward.
Then mount the new housing hood in the reverse order ( 3,2,1).
Attaching the diffusor foil
Diffusor DCR 200i…
Warning
- The diffusor foil (50131459) is not suitable for use in combination with the polarization filter!
- Before attaching the foil, make certain that the surface is free of dust and grease!
- When attaching the diffusor foil, take care to prevent bubbles from forming under the film!
- Make certain that the diffusor foil is correctly oriented (small opening at top, large opening at bottom).
- Attach the foil to the housing screen from bottom to top.
Order guide
Housing hood with / Designation / Part no.
- Plastic screen / Cover DCR 200i / 50131462
- Glass screen / Cover DCR 200i-G / 50131461
- Glass screen and polarization filter / Cover DCR 200i-P / 50131460
Diffusor foil
- For the screen of the housing hood / Diffusor DCR 200i / 50131459
Contact
Leuze electronic GmbH + Co. KG
- info@leuze.com
- www.leuze.com
- In der Braike 1 D-73277 Owen
- Tel. +49 (0) 7021 573-0
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>