LYT Self Cleaning Water Purifier User Guide
- June 6, 2024
- LYT
Table of Contents
LYT Self Cleaning Water Purifier
Product featured
- Destroys 99.9% of e.coli in minutes from your drinking water
- Self-cleaning activates every hour to keep your bottle odor-free
Quick Start
-
Step 1: Charge ****Charge the LYT bottle cap fully before use. Press activation button to indicates battery life. Green light indicates 40% – 100%Orange light indicates 11% – 39%
Red light indicates 1% – 10% -
Step 2: Activate Self-Cleaning
Press and hold the power button for 5 seconds to activate self-cleaning mode. LED flashes three times to indicate self-cleaning mode is active. Once self-cleaning is activated, cap will turn-on automatically every hour for a few seconds to keep your bottle odor-free. -
Step 3: Fill
Fill your bottle with tap water. Note: not suitable with water from stream or a river. -
Step 4: Cap
Screw on the LYT bottle cap and tighten for proper seal. -
Step 5: Purify
Gently press button on top of cap 2 times to purify the water. This destroys 99.9% of e.coli in 3 minutes from your drinking water. Product not tested on viruses and pathogen
Safety precautions
- Do not irradiate eyes with UV-C light
- Not intended or not suitable for use by children
- Do not activate the cap without installing on the bottle
- Use only with tap water or transparent water source free of debris.
- Not suitable for water from river or stream
FCC Statement
Manufactured for UBO-Technologies, LLC at EPA Est. No. 98267-FL-1
Directions to use: This products must be used according to the
instructions listed on the manual. Manual is on the back side of this label.
Caution: This product is not suitable or intended for use by children.
This product contains Lithium-ion battery and uses Ultraviolet radiation. See
Manual for complete directions of use and safety warnings.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>