SHARGE C2 10000mAh CarbonMag Power Bank User Manual

: August 17, 2024
: SHARGE

Table of Contents

SHARGE C2 10000mAh CarbonMag Power Bank
Package Contents
Product Information
Product Introduction
FCC STATEMENT
CONTACT
Read User Manual Online (PDF format)
Download This Manual (PDF format)

SHARGE C2 10000mAh CarbonMag Power Bank

Package Contents

Product Information

Product Name: CarbonMag Power Bank
Model: C2
Port Type: USB-C
Input:
- USB-C: 5V 3A/9V 2.22A
Output:
- USB-C: 5V 2A/9V 2.22A
Total Output: 5V 3A
Wireless Output: 15W Max
Battery Capacity: 10,000mAh/3.87V/38.7Wh
Rated Capacity: 6,000mAh (5V-2A)
Conversion Rate: ≥77%
Dimensions: 102 × 70 × 14.6mm
Weight: ≈1809

Product Introduction

Use the charging cable to charge your power bank.
The USB-C and wireless charging of the power bank can automatically recognize the output. When wireless charging is active, the blue light stays on, and the white light displays real-time battery level. When the USB-C output is active, the white light stays on, displaying real-time battery level.
The power bank supports simultaneous charging and discharging. At this time, the blue light remains on, and the white light flashes. When the power bank is fully charged, the white light stays on.
Single press the button to check the power level of the power bank, double press the button to turn off the output, and the power bank enters shutdown mode.
When the power bank detects metal objects, the blue light flashes rapidly for 5 seconds before turning off, and the power bank enters shutdown mode.

Note: Do not place the power bank too close to cards with magnetic strips or chips (such as ID cards, bank cards, etc.) to avoid deactivation of the cards.

FCC STATEMENT

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used under the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired operation.

This symbol indicates that this product shall not be treated as household waste. Instead, it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment.