TUFSKINZ TAC181,TAC185 Inner Bedside Overlays Instruction Manual
- August 17, 2024
- TUFSKINZ
Table of Contents
TUFSKINZ TAC181,TAC185 Inner Bedside Overlays
Product Specifications
- Product Name: Tacoma Inner Bedside Overlays
- Model Numbers: TAC181 & TAC185
Product Usage Instructions
Installation Preparation:
Prepare the area for installation by following these steps:
- Clean the surface where the overlays will be applied to ensure proper adhesion.
- Ensure the surface is dry and free from any dust or debris.
- Inspect the overlays for any defects or damages before proceeding with installation.
Installation Steps:
- Start by carefully positioning the overlays on the designated area.
- Peel off the adhesive backing and gently place the overlays on the surface, ensuring proper alignment.
- Press down firmly on the overlays to secure them in place.
FAQ
Frequently Asked Questions
- Q: How do I contact support for this product?
- A: For any questions or support, please reach out to Sales@TUFSKINZ.com.
- Q: Where can I find more information and updates about the product?
- A: Follow TUFSKINZ on Instagram and Facebook @TUFSKINZ for the latest updates and information.
Please read all instructions before installation.
Tools And Materials Needed
- 50/50 Mix isopropyl alcohol/water
- Scratch resistant cloth
- 1500 watt hair dryer*(If necessary)(DO NOT use heat gun)
Installation Preparation
- Apply alcohol and water cleaning mixture to a scratch resistant cloth. Do not apply cleaning mixture directly to vehicle surfaces.
- Clean installation surface area thoroughly and wipe dry immediately with a new clean cloth.
- Ensure parts AND vehicle surface are between 70°F and 110°F at time of installation. *If necessary a hair dryer may be used to reach desired temperature.
Installation
- Before peeling adhesive liner, dry fit parts on installation surface to check for proper fit and placement.
- Remove the adhesive liner from the middle cut out as shown in Figure 1 and align around light as shown in Figure 2. This will help you align the product accurately.
- Gradually remove the adhesive liner while working outward as shown in Figure 3. Use a plastic scraper to help apply the product smoothly and avoid trapping any air bubbles.
- Make any necessary adjustments and press the product firmly against the surface to ensure a secure bond.Using these steps will help ensure a smooth and secure installation.
Questions or Support?
- Contact: Sales@TUFSKINZ.com
- Follow us on Instagram & Facebook @TUFSKINZ
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>