Fish Mate F14 Automatic Fish Feeder Instruction Manual
- August 9, 2024
- Fish Mate
Table of Contents
Fish Mate F14 Automatic Fish Feeder
INTRODUCTION
The Fish Mate F14 Automatic Fish Feeder is a safe way to make sure that your tank fish always eat at the same time. This automatic feeder can give your fish up to 14 separate meals, so they’ll be well fed even when you’re not there. You can use the Fish Mate F14 for both warm and cold-water fish, and you can change the size of the portions to suit your needs. This feeder is easy to set up and works reliably. It helps you control your fish’s food intake, so you don’t have to worry about feeding them too much or too little. If you’re a busy aquarist or just want to make taking care of your fish easier, the Fish Mate F14 is a useful and handy tool.
Positioning of feeder
- Your F14 feeder should normally be positioned on the aquarium hood with its food exit spout positioned over the feeding hole provided in the aquarium hood.
- If your aquarium is not provided with such a hole you will need to cut a hole diameter 30mm (11/4’’). (Fig. 1.)
- It is not normally recommended that the feeder be installed on the condensation tray (fitted on some aquariums under the lighting hood), as excessive moisture in this area can cause food clogging.
- However, such installation may be satisfactory if an air pump is connected to the small connector marked “AIR” under the feeder, as this will normally prevent the ingress of moist air. (Fig. 2.)
- On aquariums without a hood, the feeder should normally be mounted on the two tank clamps supplied after pulling out the two rear rubber feet.
- Screw the clamps to the top edge of the aquarium in the required position so that the feeder may be placed on this mounting.
- Check the security of clamps before use. (Fig. 3.)
- The F14 feeder is not designed for use outside on fishponds.
Operation
- Turn it upside down, remove the timer cover, insert the AA battery, and switch on the timing mechanism. Check battery operation by the visible movement of the gearwheel. (Fig. 4.) Replace the timer cover.
- Place the unit in the required position and lift the lid. Align the hole in the rotor with the food exit spout. (Fig. 5.) Ensure the rotor is the correct way up as indicated in Fig 6.
- Insert mealtime pegs in the required locations in the timer knob (Fig. 7). (Note: 4 mealtime pegs are supplied, but extras are available.) Set the time on the inner dial by rotating the timer knob anti-clockwise until the current time lines up with the indicator arrow. (In Fig. 7 the current time is 11 am and the fish will be fed at 6 pm today and daily thereafter at 6 am and 6 pm.) The food is dispensed gradually over a period of approximately 2 hours, as this is better for the fish.
- Fill the required number of compartments in the rotor, starting clockwise from the food exit spout for the first meal. Close the lid. (Fig.8.)
Testing your F14 feeder before use
- Your FISH MATE feeder is manufactured from top-quality materials and is assembled to comply with rigorous quality standards.
- Consequently, it should give you many years of dependable use.
- However, before using it for the first time, we recommend you supervise its correct operation over a fourteen-day period when you are present.
- Problems of food clogging or not falling out may occasionally be experienced where condensation occurs inside the feeder.
- Some foods are more likely to clog. (If clogging occurs, try pellet food).
- The clogging may be due to the spray produced by an air pump.
- If so, try moving the airstone to a location remote from the feeding hole, and/or reducing the air flow rate.
- You may also try raising the feeder 25-50mm (1’’-2’’) above the feeding hole and leaving the lid of the feeder open.
- In extreme cases, it is possible to connect an air pump to the small connector marked “AIR” under the feeder, thus pressurizing the feeder and preventing the ingress of moist air.
FEATURES
- Meal Capacity for 14 Days: Gives out up to 14 separate meals over two weeks.
- Adjustable Portion Sizes: Portions can be changed to fit different types of fish.
- Battery Operated: It only needs one AA battery to work.
- Easy Setup: It’s easy to set up and program in any tank.
- Mounting Options: It can be connected to the glass, the tank hood, or a ledge.
- All types of fish food can be used: It can be used with chunks, flakes, or pellets.
- Waterproof: This keeps your fish’s food dry and fresh.
- Low Battery Indicator: This lets you know when the battery needs to be changed.
- Clear Lid: This makes it easy to see how much food is inside.
- Reliable Dispensing Mechanism: Makes sure that food is always the same.
- Silent Operation: It works quietly so it won’t bother your fish too much.
- Small Size: It fits easily into any tank setup.
- Long battery life for long use; uses little energy.
- This is a great way to feed your fish while you’re on vacation.
- Trusted Brand: It was made by Fish Mate, which is known for making good water items.
Cleaning
- We normally recommend that you remove the rotor after 14 days’ continuous use and dust off any remaining food fragments from underneath the rotor and from its seating face on the body.
- In practice, you may find this unnecessary due to the patented self-cleaning action of the rotor but much will depend on the type of food being used.
Batteries
We recommend an alkaline battery size ‘AA’. This battery should last 12 months in continuous use. It is recommended to remove the battery when the feeder is not being used for prolonged periods.
CONTACT INFORMATION
- www.pet-mate.com
- +44 (0)1932 700 001
- N America (936) 760 4333
3 YEAR LIMITED GUARANTEE
Pet Mate Ltd. guarantees your product for a period of three years from the date of purchase, subject to proof of purchase date. The guarantee is limited to any defect arising due to faulty materials or manufacture. Any defective item will be repaired or replaced free of charge at the manufacturer’s discretion, provided that the defect has not been caused by neglect, misuse, or normal wear and tear. Your statutory rights are not affected.
FREQUENTLY ASKED QUESTIONS
What is the recommended use for the Fish Mate F14 Automatic Fish Feeder?
The Fish Mate F14 Automatic Fish Feeder is designed for use with multiple pets, specifically fish.
What material is the Fish Mate F14 Automatic Fish Feeder made of?
The Fish Mate F14 Automatic Fish Feeder is made of polypropylene.
What special features does the Fish Mate F14 Automatic Fish Feeder offer?
The Fish Mate F14 Automatic Fish Feeder offers portability, portion control, durability, and a feeding schedule.
What is the price of the Fish Mate F14 Automatic Fish Feeder?
The Fish Mate F14 Automatic Fish Feeder is priced at $22.49.
What are the dimensions of the Fish Mate F14 Automatic Fish Feeder?
The dimensions of the Fish Mate F14 Automatic Fish Feeder are 4.65 x 5.47 x 1.54 inches.
How much does the Fish Mate F14 Automatic Fish Feeder weigh?
The Fish Mate F14 Automatic Fish Feeder weighs 8 ounces.
What is the item model number for the Fish Mate Automatic Fish Feeder?
The item model number for the Fish Mate Automatic Fish Feeder is 207.
What type of battery does the Fish Mate F14 Automatic Fish Feeder require?
The Fish Mate F14 Automatic Fish Feeder requires 1 AA battery.
Who is the manufacturer of the Fish Mate F14 Automatic Fish Feeder?
The manufacturer of the Fish Mate F14 Automatic Fish Feeder is Ani Mate Inc.
What type of fish is the Fish Mate F14 Automatic Fish Feeder suitable for?
The Fish Mate F14 Automatic Fish Feeder is suitable for feeding fish.
What does the portable feature of the Fish Mate F14 Automatic Fish Feeder include?
The portable feature of the Fish Mate F14 Automatic Fish Feeder allows for easy transport and placement in different locations.
What should I do if my Fish Mate F14 Automatic Fish Feeder is not turning on?
Check that the feeder has fresh batteries installed correctly. Ensure that the battery compartment is clean and the batteries are properly connected. If it still doesn’t turn on, there might be an issue with the internal electronics.
Why is my Fish Mate F14 Automatic Fish Feeder not dispensing food?
Verify that the food compartment is filled and not clogged. Make sure the feeder is correctly set up and programmed. If the feeder still does not dispense food, the dispensing mechanism might be jammed or defective.
What if the Fish Mate F14 Automatic Fish Feeder is not following the programmed feeding schedule?
Double-check the feeding schedule settings to ensure they are programmed correctly. Make sure the current time is set accurately on the feeder. If the feeder is still not following the schedule, there might be an issue with the internal clock or programming.
Why is the Fish Mate F14 Automatic Fish Feeder not operating consistently?
Ensure that the batteries are fresh and fully charged. Check for any obstructions in the food dispensing mechanism. If the problem persists, the feeder’s internal components or motor may need to be inspected.
DOWNLOAD THE PDF LINK:Fish Mate F14 Automatic Fish Feeder Instruction Manual
REFERENCE:Fish Mate F14 Automatic Fish Feeder Instruction Manual- Device.Report