LEDWOOD AUDIO VISTACAM4K42 Wireless Headphones and Speakers Instructions

LEDWOOD AUDIO VISTACAM4K42 Wireless Headphones and Speakers

SAFETY INSTRUCTIONS

Please read this manual carefully, as it contains important information on installation and operation.
Keep this manual for future reference. If the unit ever changes ownership, please ensure that the new user is in possession of the manual.

• Ensure that the mains voltage is suitable for this device, and does not exceed the voltage specified on the nameplate.

• To avoid risk of fire or electric shock, do not expose this device to rain or moisture. Make sure that no flammable objects are in the vicinity of the unit during operation.

• Do not expose the unit to dripping or splashing water.

• Do not place naked flames, such as lighted candles, on the unit.

• To ensure adequate ventilation, install the unit in a well ventilated location at a minimum distance around the unit of 50 cm. Ventilation must not be impeded by obstructing ventilation openings with objects such as newspapers, tablecloths, curtains, etc.

• Unplug the unit from the mains before carrying out any maintenance or servicing.

• The unit is intended for use in temperate climates. The ambient temperature must not exceed 40°C. Do not operate the unit at higher temperatures.

• In the event of a malfunction, switch off the unit immediately. Never attempt to repair the unit yourself.
  Incorrect repairs may result in damage or malfunction. Contact an authorized service center.

• Ensure that the power cord is never crushed or damaged.

• Never unplug the unit by pulling on the cord.

• Do not expose your eyes to the light source for too long.

• Batteries must be inserted with the correct polarity.

• Batteries must be disposed of safely. Dispose of them in the appropriate collection bins ( ask your dealer). your dealer) to protect the environment.

• Do not charge the product when it is wet.

WARNING Danger of explosion if battery is incorrectly replaced. Replace only with same or equivalent type. type. Batteries must not be exposed to excessive heat such as sunshine, fire or similar sources.

INFORMATION
If you wish to return your LEDWOOD product, please contact the seller from whom you purchased it. Our products are covered by the European legal conformity guarantee for 2 years.
Safety extra-low voltage (SELV) or protective low voltage (PL V) supply, ungrounded masses, safe supply CLASS III ( safety transformer). Danger of electrocution!

PACKAGE CONTENTS

• 1 camcorder
• 1 battery
• 1 remote control
• 1 case
• 1 USB-C cable

TECHNICAL SPECIFICATIONS

Do not dispose of appliances bearing th!s symbol in household waste. Help protect the environment and your own safety by recycling your electrical and electronic products. The device and its packaging must be taken to your local collection point for recycling. Contact your local authorities for information on disposal and recycling. Sonne collection centers accept products free of charge.

Recycling Our packaging may be subject to sorting instructions. To find out more, go to www.consigneetri.fr
ENVIRONMENTAL PROTECTION – DIRECTIVE 2012/19/UE

CHARGING CAUTION   if the product is to be left unused for a long period, leave the RECHARGING battery fully charged, otherwise the battery may be damaged
Recharge the product at least every 2 months. Do not expose your device to extreme temperatures {above 50°C) (e.g. direct sunlight in a closed vehicle, near a heat source or radiator, etc.).

High temperatures can damage speaker performance and shorten battery life.

CHARGING INSTRUCTIONS

Before using the product, you must insert the battery correctly into the slot (17) and fully charge the battery.

1. Connect the USB power cable to the « USB-C» socket (14), then to the USB or mains socket via an adapter.
2. Once the battery is fully charged, the LED indicator appears on the display (11), then disconnect the cable.
3. Insert a memory card (128GB max) in slot (15).
4. Press the «01′-VOFF» button (9) or open the display (11) to switch on the device.

REMAINING BATTERY TIME INFORMATION

1. EXT microphone slot
2. Zoom +/- button
3. LED indicator
4. Recording on/off
5. Next
6. Previous
7. Mode
8. Menu
9. On / Off I Light
10. Speaker
11. Screen
12. EXT microphone input
13. Photo
14. USB-C input
15. SD card slot
16. Battery slot
17. Battery cover
18. Tripod support

DATE AND TIME SETUP AND LANGUAGE

1. Press the « MENU» button, then press the « MODE» button to enter the system.
2. Press the up or down button to move the cursor.
3. Select the time and date setting sub-menu and press the OK button to enter the setting.
4. After setting, press «MENU » to exit.

MICRO SD MEMORY CARD (NOT INCLUDE)
Before inserting a micro SD card into slot (15), make sure to format the card.

VIDEO MODE

1. Press the «01′-VOFF» button (9) or open the display (11) to switch on the device.
2. Press the « MODE» button (7) and select «CAMERA» mode using the navigation buttons (5 and 6) or (2).

To trigger a video, simply press the record button (4) once, and video recording starts.
To stop recording, press the shutter button (4) a second time.
Note : to pause recording, press the « Photo» button (13).

PHOTO MODE

1. Press the «01′-VOFF» button (9) or open the display (11) to switch on the device.
2. Press the « MODE» button (7) and select « PHOTO» mode using the navigation buttons (5 and 6) or (2).
   To take a photo, simply press the shutter release button (13) once, the shot is taken and stored on the memory card.

VIDEO & PHOTO MODE
The camcorder features several video and photo modes:

Video recording mode : Video, Slow Motion, Lapse.
Photo shooting mode: Photo, Auto, Dramatic shooting, Timed shooting.

Playback mode

VIDEO SCREEN INTERFACE

1. Video mace
2. Resolution
3. Current and remaining recording time
4. Battery life
5. Zoom in/zoom out
6. Zoom factor
7. Adjustment function
8. System time
9. System date
10. Exposure parameters
11. Sensitivity setting
12. Metering mode setting
13. Scene setting
14. White balance setting
15. Multimedia playback settings
16. Main menu button

PHOTO SCREEN INTERFACE

1. Photo mode
2. Resolution
3. Photo quality
4. Current and remaining recording time
5. Battery life
6. Zoom in/zoom out
7. Zoom factor
8. Adjustment function
9. System time
10. System date
11. Exposure parameters
12. Sensitivity setting
13. Metering mode setting
14. Scene setting
15. White balance setting
16. Multimedia playback settings
17. Main menu button

PLAYBACK MODE
Press the « MODE» button, then select the « PLAYBACK» mode, in which you can view videos and photos taken. If there is no me­mory card, or no files, a zero value will be displayed when entering playback mode.

DELETE VIDEOS & PHOTOS
In playback mace, find the video or photo you wish to delete by scrolling up or down the screen, then click on the delete button displayed on the screen.

CONNECTING TO A COMPUTER
Connect the camcorder to the computer’s USB port using the USB cable, and the camcorder will switch on automatically.
Press the up and down buttons to select USB / PC camera/ loading mode, then press ok to confirm.

USB mode: a removable storage device will be added to your computer.
PC camera mode: the camera can be used as a webcam. After switching on the webcam, you can press the or button to adjust the digital focal length to the appropriate distance.
Charging mode: all camera and video functions can be used normally while the camera is charging.

REMOTE CONTROL

1. On/Off
2. Start/ Stop recording
3. Camera
4. Top navigation
5. Mode
6. OK
7. Right
8. Down navigation
9. Light on/off
10. Zoom+ button
11. Zoom out
12. Menu
13. Left
14. Playback

TROUBLESHOOTING

No power: first check that the camera is switched on « POWER» If this is the case, please check that the battery is correctly installed and fully charged.
Unable to charge: If the charge indicator is flashing, the battery is not installed or is in poor contact. Please reinstall the battery until the blinking LED is on for a longer period (the LED will go out when the battery is full).

Remote control does not work

• A Remote control insulation paper not removed.
• B Check batteries.
• C Remote control not pointed at signal receiver in front of camera lens.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>