Vollrath R39736 Cafeteria Breath Guard Installation Guide
- August 8, 2024
- VOLLRATH
Table of Contents
Vollrath R39736 Cafeteria Breath Guard
Specifications
- Model: One Piece and Three Piece Cafeteria Breath Guard
- Item No.: 2350030-01 Rev 04/12
Frequently Asked Questions
Q: What should I do if I overtighten the cap nuts during installation?
A: Overtightening may cause the plastic to crack. If you have overtightened the cap nuts, carefully loosen them and adjust to the appropriate tightness to avoid damage.
Q: Can I install the breath guard without using all the components mentioned in the instructions?
A: It is recommended to follow the installation instructions provided to ensure proper assembly and functionality of the breath guard.
Installation Instructions
One Piece cafeteria Breath Guard three Piece cafeteria Breath Guard
These instructions cover the installation of the one pice Cafeteria Breath Guard and the three piece Cafeteria Breath Guard.
One Piece Breath Guard installation
Some units are shipped with a breath guard not installed. To install the
breath guard follow these steps:
NOTE:
Use caution when tightening the cap nuts. Overtightening may cause the plastic
to crack.
-
Install the breath guard uprights (A) to the studs (B) securing with cap nuts (C) as shown. See Figure 1. Repeat for all four uprights.
-
Install the breath guard support tube (D) between the uprights (A) securing with cap nuts (C) as shown. Repeat on the other side.
-
Install the one piece breath guard (E) securing with screws (F) and cap nuts (C) as shown. Repeat for all four mounting locations.
-
Install the side breath protector (G) to the support tube (D) securing with cap nuts (C) as shown. Repeat on the other side.
three Piece Breath Guard installation
Some units are shipped with a breath guard not installed. To install the
breath guard follow these steps:
NOTE:
Use caution when tightening the cap nuts. Overtightening may cause the plastic
to crack.
-
Install the breath guard uprights (A) to the studs (B) securing with cap nuts (C) as shown. See Figures 1 and 2. Repeat for all four uprights.
-
Install the breath guard support tube (D) between the uprights (A) securing with cap nuts (C) as shown. Repeat on the other side.
-
Install the side breath guards (E) securing with screws (F) and cap nuts (C) as shown. Repeat for all mounting locations.
-
Install the side shield (G) to the support tube (D) securing with cap nuts (C) as shown. Repeat on the other side.
-
Install the support bar and stud assembly (H) to the side breath guards (E). Repeat for all mounting locations.
-
Install the top breath guard (I) to the support bar and stud assembly (H) securing with cap nuts (C). Repeat for all mounting locations.
The Vollrath Company, L.L.C. 1236 North 18th Street Sheboygan, WI 53081-3201
U.S.A.
Main Tel: 800.628.0830 Service Tel: 800.628.0832 FAX: 800.752.5620
Vollrath of Canada, Co.
Tel: 800.695.8560
FAX: 800.752.5620
© 2010 The Vollrath Company, L.L.C.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>