kwikboost KB94018 Wall Mount Mini Charging Hub Instruction Manual
- August 2, 2024
- kwikboost
Table of Contents
kwikboost KB94018 Wall Mount Mini Charging Hub
Specifications:
- Product Name: Mini Charging Hub Wall Mount
- Compatible Devices: Phones and tablets (not compatible with laptops)
- Required Hardware: Zip Ties (3), Wall Anchor (4), Mounting Screw (4), Drill & 3/16 Drill bit
Product Usage Instructions
Installation Tips:
Use the lines on the drilling template to ensure the unit is level during
installation.
Assembly Steps:
- Drive mounting screws into the top two wall anchors, leaving a small gap from the wall.
- Set the charging station face down on a flat surface, connect the power supply, and secure the cord using zip ties and pads.
- Mark the location of the charging hub using the drilling template. Place it directly above an available wall outlet.
- Drill 4 holes with a 3/16 drill bit, insert wall anchors, then align and secure the unit on the wall using mounting screws.
- Align the keyholes on the column to the mounting screws, slide down to secure, then use the remaining screws to secure the bottom of the column.
- Plug the power supply into a wall outlet once mounting is complete.
FAQ:
Q: What devices are compatible with the Mini Charging Hub Wall Mount?
A: The Mini Charging Hub Wall Mount is compatible with phones and tablets
only. It is not compatible with laptops.
Q: Where can I find more information or get support?
A: For more information or support, visit LuxorWorkspaces.com or contact
customer service at 800-323-4656.
Included Hardware:
Required Hardware:
Installation Tips
Use the lines on the drilling template to make sure the unit is level.
Assembly
Use the drilling template, mark the location of the charging hub. TIP: Place the hub directly above an available wall outlet, if possible.
Using the markings created with the drilling template, drill 4 holes with a 3/16” drill bit. After drilling, insert a plastic wall anchor into each of the holes.
Drive mounting screws into the top two wall anchors. Do not drive them until they are flush against the wall. Leave a gap of approximately 1/8”.
Set the charging station face down on a flat surface. Connect the power supply then secure the cord to the inside of the column using the supplied zip ties and pads.
Align the keyholes on the top rear of the column to the mounting screws on the
wall. Slide the unit down so the screws sit snugly inside the keyholes, as
shown. Once properly positioned, the mount holes at the bottom of the column
should line up with the remaining 2 wall anchors. Once aligned, secure the
charging station using the remaining mounting screws.
Once mounting is complete, plug the power supply into a wall outlet.
IMPORTANT: Phone/tablet charging only.
Not compatible with laptops
Need more info?
LuxorWorkspaces.com |
800-323-4656