WISFREAST B0D2ZWCT69 Smart Watch Instruction Manual
- July 31, 2024
- WISFREAST
Table of Contents
B0D2ZWCT69 Smart Watch
“`html
Specifications:
-
Compliance: FCC Part 15, Industry Canada licence-exempt
RSS -
Conditions of Operation: Must not cause harmful interference;
must accept any received interference -
Approval: Changes or modifications not approved could void
user’s authority
Product Usage Instructions:
1. Compliance
Ensure that the device is used in accordance with FCC Part 15
regulations and Industry Canada licence-exempt RSS standards to
avoid interference issues.
2. Power On/Off
To power on the device, press and hold the power button for 3
seconds. To power off, repeat the same step.
3. Connectivity
Follow the user manual to establish connections with other
devices. Make sure the device is within the recommended range for
optimal performance.
4. Maintenance
Regularly clean the device using a soft, dry cloth. Avoid using
liquid or abrasive cleaners that may damage the device.
FAQ:
Q: What should I do if the device causes interference?
A: If interference occurs, try adjusting the positioning of the
device or relocating it to minimize interference with other
electronics.
Q: How can I reset the device if needed?
A: To reset the device, locate the reset button (usually at the
back) and use a paperclip to press and hold it for 10 seconds until
the device restarts.
“`
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures: — Reorient or relocate the receiving antenna. —
Increase the separation between the equipment and receiver. — Connect the
equipment into an outlet on a circuit different from that to which the
receiver is connected. — Consult the dealer or an experienced radio/TV
technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
– English: This device complies with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions: (1) This
device may not cause interference, and (2) This device must accept any
interference, including interference that may cause undesired operation of the
device.
– French: Le présent appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes: (1) l’appareil ne doit pas produire
de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>