GeoSIG GMSplus Set RTC Time from Recorder Serial Console User Manual
- July 31, 2024
- GeoSIG
Table of Contents
GeoSIG GMSplus Set RTC Time from Recorder Serial Console
USER MANUAL
FAQ GMSplus Set RTC Time from Recorder Serial Console
1. Introduction
This procedure describes how to set the time of the GMSplus realtime clock (RTC) manually.
2. Required Tools
GMSplus
Computer, connected to Recorder Serial Console with ucon
https://www.geosig.com/files/FAQ_GMSplus_How_to_Connect_Serial_Console_with_uCon.pdf
3. Set RTC Time
In the main menu, select [H] to set RTC time
-
Enter the time in format YYMMDDHHMMSS and confirm with [Enter] The sample below is for a time of 18:45:00 on January 19th of 2024
-
When entering the time, it may happen that log messages are written into your input.
If this happens, just continue your input and confirm with [Enter]
The input may be split over several lines as below -
GMSplus will adapt its time to the new setting, it will close the old ringbuffer recording (RBF) andopen a new one with the new time setting.
This process may take a few seconds.
4. Check RTC Time
In the main menu, select [G] to see the current RTC time
-
In the main menu, select [G] to view current RTC time.
-
Current RTC Local Time is displayed in format YYYY.MM.DD
HH:MM:SS.ms. -
If new time isn’t reflected, repeat from step 3. and check
backup battery voltage. Refer to FAQ’s Maintenance Guideline for more details.
Specifications
-
Product Name: GMSplus
-
Function: Realtime Clock (RTC)
-
Manufacturer: Geosig
-
-
FAQ – Frequently Asked Questions
GMSplus Set RTC Time from Recorder Serial Console
Q: How do I set the RTC time manually on GMSplus?
A: Follow steps outlined in the user manual under “Set RTC Time” section.
Q: What should I do if the new time is not reflected?
A: Check backup battery voltage and refer to the FAQ’s Maintenance Guideline for troubleshooting.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>