ACEBEAM M2-X Terminator EDC Flashlight User Manual
- July 26, 2024
- ACEBEAM
Table of Contents
**ACEBEAM M2-X Terminator EDC Flashlight User Manual
**
FEATURES
- Multi light sources: 1 x Spotlight LED, 3 x Floodlight LEDs, 1 x AUX Light
- Floodlight max output: 3200 lumens, Beam throw: 178 meters
- Spotlight max distance: 500 meters, 62500cd, Max Output: 900 lumens
- One spotlight plus four brightness levels of floodlight to cycle
- Easy to switch light sources or brightness modes to meet different applications
- AUX Light: Seven-color automatic cycle Red, Green, Blue, Green-Signal and Red-SOS
- Temperature control system: keeps light from overheating so it can run brighter and longer
- Tail stand capability
- Impact resistance: 1.5m
- Waterproof: IP68, underwater 2m
INCLUDED
1 x ACEBEAM M 2-X; 1x ACEBEAM 18650 Type-C Rechargeable battery; 1x Type-C
charging cable; 1x Lanyard; 2 x O-rings; 1x Warranty card; 1x User manual
SPECIFICATIONS Size: 95.4mm(Length)x 48.5mm(Head)x 29mm(Body)
Weight: 197.2g/6.95 oz (Including battery)
TECHNICAL PARAMETER
Floodlight Cool White 6500K
FL 1
STANDARD| Turbo| High| Med 2| Med 1| Low| Moonlight
| 3200-1200
-50 Iumens| 1200-50 lu mens| 500-50
lumens| 200-50
lumens| 50
lumens| 1
lumen
| 110s +
1hlOmin+25 min| 1 h 15 min +
25 min| 3h +
25min| 7h +
25 min| 18.5 h| 38 h
| 178m| 119 m| 79 m| 54 m| |
| 7921cd| 3540 cd| 1560 cd| 729 cd| |
Spotlight| | High| 900-400
lumens| | 50s +
1h5Omin| | 500m| | 62500
cd
---|---|---|---|---|---|---|---|---|---
FloodlighSpotlight| | High| 2700-1000
lum| | 50s +
1h1| | 440m| | 48400
cd
| Strobe| 1900
lumens| | 1 h
30min| | 350m| | 30625
cd
AUX Light
FL1
STANDARD| Seven-color| Red| Green| Blue| Green-Signal| Red-SOS
| 0.5 Iumens| 0.5 Iumens| 0.5 Iumens| 0.5 Iumens| 0.5 Iumens| 0.5 Iumens
| 300h| 383h| 437h| 491 h| 1194 h| 1042 h
Notice: The above-mentioned parameters (tested with 1xACEBEAM 18650 battery) are approximate and may vary from flashlights, batteries, and environments. Using a quality 18650 battery with circuit protection (at least over 10 Amps of current) is recommended.
OPERATING INSTRUCTION
Tail Power Switch Operation:
ON: Click the Power Switch.
OFF: Click the Power Switch when
ON. Output Selection : When the Floodlight source option is ON, press and
hold the Power Switch, and the floodlight will cycle from Low-Med1-Med2-High,
release the Power Switch to select the output, and can be memorized next ON;
Remark: There is only one brightness level for Spotlight.
Turbo: In the Unlocked state and under the flood light source option,
double-click the Power Switch quickly to enter the Turbo output, and double-
click again to switch between Turbo and memory output; Moonlight: When the
flashlight is OFF and under the floodlight source option, press and hold the
Power Switch for 0.5seconds to enter the Moonlight output;
Strobe: In the Unlocked state, triple-click the Power Switch to enter the
Strobe output (Both floodlight and spotlight strobe at the same time);
Side Switch Operation:
Floodlight &Spot light exchange: When the light is ON, single click the
Side Switch, the light output will exchange between floodlight source or
spotlight.
Mix Mode: When the light is ON, quickly double-click the Side Switch to
enter Mix mode (Both floodlight and spotlight ON at the same time);
RGB colored mode: When the flashlight is ON, press and hold the Side
Switch to cycle through: Seven-Color light automatic cycle mode -red-green-
blue -Green Signal -red SOS. Moonlight, Strobe, Turbo, Mix Mode and RGB
colored mode will be not memorized.
Lock/Unlock
Lock: When the light is OFF, press and hold the Tail Power Switch for 3
seconds, the current light source will flash 3 times, and the flashlight will
be Locked. At this time, any switch operation will be invalid. Unlock: When
the light is Locked, press and hold the Tail Power Switch for 3 seconds, the
current light source will flash 3 times, and then Unlock the light. The
Floodlight will be Moonlight ON when unlocked.
LOW-VOLTAGE WARNING
With the lamp switched on, and the voltage drop below 10%, the lamp is programmed to Low, to remind you to charge/replace the battery. When the 18650 battery voltage drops below 2.7V, the lamp will turn off automatically.
BATTERY VOLTAGE WARNING
Green light: >20%
Red light: among 20%~10%, low battery warning
Red flash light: <10% The light would be turned off when the voltage is
below 2.7V
**INSULATING FILM
BATTERY INSTALLATION
**
FAQ & SOLUTIONS
| Problems | Causes | Solutions |
|---|---|---|
| Abnormal flash or failure to turn on | Check if the switch is turned on | |
| correctly | Double Click to Turn on the Light | |
| Check if it is assembled in place | Tighten the assembly parts | |
| Check if the battery is no power | Try the battery on other products | |
| Check if the battery is reversed | Remove the battery and reassemble it |
correctly
Check if the conductive positionis dirty| Clean the surface with alcohol
Abnormalnoise| Check if foreign matter falls inthe tube| Pour out possible
foreign matter
Part damage| Contact your seller
WARNING
- CAUTION! Possible dangerous radiation! Don’t look into the light! May be dangerous for your eyes.
- By using this device, you certify you have read the included User Manual and Warning Card and release the manufacturer and retailers from all liabilities.
- Please use in accordance with applicable laws and regulations.
- Quality batteries with circuit protection will reduce the potential risk.
- Do not aim this light directly at eyes or exposed skin to prevent injuries. Keep this flashlight out of the reach of children.
USAGE AND MAINTENANCE
- Unauthorized disassembly may damage the light and void the warranty.
- This is normal case the light will accumulate a lot of heat when used on Turbo output levels for extended periods.
- Lubricate the threads with professional grade lubricant regularly.
- Please swap out the O-rings regularly to maintain the water resistance level.
- Maintain and keep clean any contact surfaces of the flashlight with alcohol swab. This may prevent irregular flashes during use.
- Remove batteries during storage. Keep lithium-ion batteries charges approximately every 4 months.
- This flashlight may not be used as diving light.
PRODUCT WARRANTY
-
We replace any quality defective lights within 15 days of purchase.
-
We offer warranty within 60 months of purchase if problems develop with normal use for LED model, 12 months for LEP model, battery, battery pack, charger, remote switch and other accessories. 3. Limited lifetime warranty, we charge for replacement parts.
-
The warranty does not cover damage or failure caused by:
A. Rough usage or operation which does not comply with the user manual or product specifications.
B. Unauthorized disassembly, repair or modification. Defects or damaged caused by factors out of Acebeam’s control.
C. Battery leakage damaged products. -
If there are any questions about ACEBEAM products, please consider the warranty and contact Acebeam or your original Acebeam dealer for warranty return instructions.
Email: info@acebeam.com
DISCLAIMER CLAUSE
Acebeam is not liable for damages or injuries sustained resulting from the
usage of the product inconsistent with the warnings in the manual.
Wechat: ACEBEAM01
FB: AcebeamWorld
SHENZHEN ZENBON TECHNOLOGY CO., LTD
+86-0755-23036551
www.acebeam.com
info@acebeam.com 1/F, No.1 Building, Yijiayang
Industrial Park, Dalang,
Longhua, Shenzhen 518100, Guangdong, China
Copyright © 2024 ACEBEAM. All rights reserved.
Powered by Shenzhen Zenbon Technology Co.,Ltd
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>