All About Blanks Patriotic Sunflower Mason Jars DTF Transfer Instructions

All About Blanks Patriotic Sunflower Mason Jars DTF Transfer

Product Information

Specifications

• Product Name: DTF Transfer
• Temperature Range: 300-325 degrees Fahrenheit
• Peel Type: Hot Peel
• Contact: Phone: 678-714-2606 ext 302, Email: info@allaboutblanks.com

Product Usage Instructions

1. Pre-Heat your Heat Press to reach 300-320 degrees Fahrenheit.
2. Press your item on the side you will have your design to give it a nice smooth surface.
3. Place your DTF Transfer in the exact location you want.
4. Cover your DTF Transfer with Teflon or parchment paper of thesame size or larger to prevent lifting.
5. Use your preheated Heat Press at 300-325 degrees Fahrenheit to press down with heavy pressure for 15-20 seconds.
6. DTF transfers are hot peel, so it’s okay to peel your transfer before it’s completely cooled.

FAQ

• Q: Can I use these instructions for any heat press or iron?
  A: These instructions are general guidelines. It’s recommended to adjust based on the equipment you use and specific project needs.

• Q: What should I do if my transfer lifts during the process?
  A: Ensure that you are applying enough pressure and heat. Additionally, make sure to cover the transfer adequately with Teflon or parchment paper.

• Q: How do I know if the transfer is properly applied?
  A: The transfer should adhere smoothly to the surface without any lifting or wrinkling. If in doubt, you can gently lift a corner to check before fully peeling.

How To Apply a DTF Transfer To Your Project*

Heat Press Instructions
Pre-Heat your Heat Press to reach 300-320 degrees.

1. Press your item on the side you will have your design to give it a nice smooth surface.
2. Place your DTF Transfer in the exact location you want.
3. Cover your DTF Transfer with Teflon or parchment paper of the same size or larger. This will help avoid your transfer from lifting.
4. Use your preheated Heat Press at 300-325 degrees to press down with heavy pressure for 15-20 seconds. These transfers are a hot peel, so it’s ok to peel your DTF transfer before it’s completely cooled.

Home Iron Instructions

1. Set your iron to the highest cotton setting without steam.
2. Preheat your garment for a few seconds to remove any moisture and wrinkles.
3. Place the transfer onto the garment in the exact location you want it.
4. Apply firm and even pressure while moving the iron in a circular motion for about 20-30 seconds. A non-slip silicone pressing mat is extremely helpful in this step.
5. Take a peek to see if the design has transferred. If not, repeat steps 4 and 5 until it’s transferred onto your item.
6. These transfers are a hot peel, so it’s ok to peel your DTF transfer before it’s completely cooled.
7. Do a final press of 7-10 seconds using teflon or parchment paper.

Wash & Care Of Your Printed Item

• Turn your apparel inside out.
• Machine wash cold.
• For best results use a mild detergent with no bleach, no whitening/brightening detergent. No bleach, OxiClean, or Fabric Softeners, etc.
• Tumble dry low or hang to dry.
• Never iron over any design.

Questions?
Phone: 678-714-2606 ext 302
Email: info@allaboutblanks.com
*These instructions are general instructions and may vary depending on the type of heat press or iron you use, the item you are applying them to, and various other factors. Use these instructions as a starting point and adjust based upon your project needs.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>