Heater SPORTS SL129BB Slider Lite 360 Baseball Machine And Power Alley 22 Ft Ca Installation Guide

: July 23, 2024
: Heater SPORTS

Table of Contents

Heater SPORTS SL129BB Slider Lite 360 Baseball Machine And Power Alley 22
Product Information
Product Usage Instructions
Frequently Asked Questions
SLIDER PARTS LIST
SLIDER ASSEMBLY
Fast Ball/Curve Ball Instructions
ADDENDUM
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Heater SPORTS SL129BB Slider Lite 360 Baseball Machine And Power Alley 22

Ft Ca

Product Information

Specifications:

Model: SL129BB
Uses Slider Lite-Balls only
Recommended for adults only

Product Usage Instructions

Assembly:

STEP 1: Extend Part (B) until push-pin locks.
STEP 2: Slide Part (B) into Part (A) and lock push-pin into hole in Part (A).
STEP 3: Extend Parts (C).
STEP 4: Slide Part (C) into Part (A) and insert push-pin into hole in Part (A) (2X).
STEP 5: Slide the leg assemblies into the Tri-Pod Base (F) slots.
STEP 6: Slide Part (D) (3X) through the holes in the Tri-Pod Base (F) slot holes and tighten nut (E) (3X).

Pitch Height Adjustment:

Slide the push-pin up and down the back leg to adjust the pitch height.

Continued Assembly:

STEP 7: Slide Housing (K) onto Tri-Pod Base (F) and align mounting holes.
STEP 8: Slide Carriage Bolt (J) through mounting hole in Tri-Pod Base (F), Housing (K), add Washers, and tighten with Knob (G).
STEP 9: Attach Spiral Ball Feeder (M) and Top Spiral (L) to the Feeder Port on Housing (K).

Frequently Asked Questions

Q: Can I use real baseballs with the Slider Lite-Ball Pitching Machine?
- A: No, only use Slider Lite-Balls to prevent damage and voiding the warranty.
Q: Can children use this product?
- A: This product is recommended for adults only due to safety concerns.
Q: How do I contact customer service for assistance?
- A: Contact HEATER SPORTS at 800-492-9334 or visit www.HeaterSports.com.

Read This Before Operating

IMPORTANT

DO NOT RETURN THE SLIDER MACHINE TO THE RETAIL STORE WHERE PURCHASED.

CALL TOLL FREE: 800-492-9334.

WARNING: ONLY USE SLIDER LITE-BALLS IN THE Slider MACHINE

The Slider Lite-Ball Pitching Machine only uses Slider Lite-Balls. If you put real baseballs the Slider Lite-Ball Machine you will damage the machine and void the Slider warranty. Heater Sports recommends only using official Slider Lite-Balls in your Slider Lite-Ball Pitching Machine. These balls are incredibly accurate, long lasting, and produce the best performance in the machine.

CUSTOMER SERVICE

HEATER SPORTS is dedicated to your customer satisfaction. If you experience any trouble with the operation of the Slider Pitching Machine contact us at: 800-492-9334 or log on to www.HeaterSports.com. WARNING: THIS PRODUCT IS TO BE USED BY ADULTS ONLY. MAKE SURE MACHINE IS TURNED OFF BEFORE ASSEMBLY! KEEP HANDS AND ALL BODY PARTS AWAY FROM BALL ENTRY AND EXIT! SERIOUS HAND, EYE, AND BODILY INJURY MAY OCCUR IF USED INCORRECTLY!

Please be sure to read all of the instructions before using the Slider Lite-Ball Pitching Machine to insure the machine is working properly.
Parents: Your child should be made aware of the potential dangers of using the Slider Lite-Ball Pitching Machine.
Never put your fingers into the Slider Lite-Ball Pitching Machine.
The Slider is not a toy and an adult should supervise children. It is very important the batter makes sure the area is clear before swinging a bat.
Stay clear of the ball opening while the Slider is operating. Although the balls are very light, they may cause eye damage or other injury may occur. Children must be advised of this danger and appropriate precautions should be taken.
DO NOT use any type of ball other than Slider Lite-Balls in this machine.
Always use a NOCSE approved batting helmet when batting.
DO NOT LOOK INTO THE FRONT OF THE MACHINE WHILE THE SLIDER IS RUNNING. Occasionally a ball may get stuck in the machine. The ball may pause and then shoot out and cause eye injury. If the ball gets stuck, turn off the machine immediately. You should be able to remove the ball easily by tilting the Slider backwards to eject the ball.
Never operate in water or moisture.
Always store in a dry area.

SLIDER PARTS LIST

SLIDER ASSEMBLY

STEP 5: Slide the leg assemblies into the Tri-Pod Base (F) slots
STEP 6: Slide Part (D) (3X) through the holes in the Tri-Pod Base (F) slot holes and tighten nut (E) (3X).
STEP 7: Slide Housing (K) onto Tri-Pod Base (F) and align mounting hole of Housing (K) and mounting hole of Tri-Pod Base (F). Housing (K) should be assembled in back of Tri-Pod Base (F).
STEP 8: Slide Carriage Bolt (J) through mounting hole in Tri-Pod Base (F) and then through hole in Housing (K). Then slide Metal Washer (I) and Teeth Washer (H) onto Carriage Bolt (J). Screw Knob (G) onto Carriage Bolt (J) and tighten.
STEP 9: Slide Spiral Ball Feeder (M) on to Feeder Port on Housing (K). Slide Top Spiral (L) onto Feeder Port On Spiral Ball Feeder (M). Plug in Spiral Ball Feeder Cord into Ball Feeder Outlet located on the side of Housing (K).

Fast Ball/Curve Ball Instructions

WARNING!

ROTATING THE HEAD OF THE SLIDER FROM FAST BALL TO CURVE BALL POSITIONS CHANGES THE \DIRECTION AND TRAJECTORY OF THE PITCHED BALL. MAKE SURE NO PERSONS ARE IN FRONT OF MACHINE WHILE ADJUSTING FOR FAST BALL OR CURVE BALL PITCHES.

CAUTION:

When machine is rotated for different pitch types, the ball direction changes dramatically. Make sure no persons are in front of machine until machine is aimed properly and pitching accurately at desired target

WARNING

When machine is pivoted for different pitch types, the pitch direction can move left or right by up to 30 feet. Use extreme caution when changing between pitch types. Never change pitch types with any person in front of machine.

ADDENDUM

Front Leg Stakes

Slider Movement: The Slider may re-coil when a ball is pitched. This may cause the Slider to move slightly. To stabilize the Slider, simply slide the hook of one Front Leg Stake (N) (2X enclosed) over each of the two front legs of the Slider and pound each stake into the ground. This will stabilize the movement of the Slider Lite-Ball Pitching Machine and eliminate re-coil movement.