MINIX 2ADAC-HR HR Wireless HDMI Extender User Guide
- July 22, 2024
- MINIX
Table of Contents
MINIX 2ADAC-HR HR Wireless HDMI Extender
Quick Start Guide
-
Plug-in receiver to TV or Monitor:
Connect the wireless HDMI display receiver (RX) to your display device and power it on by plugging the USB male port into a USB power source. -
Plug-in transmitter and start screen mirroring/extension:
C1: Plug-in the transmitter C1 to your laptop, smartphone or tablet that supports DP-Alt video output and wait for wireless screen mirroring/extension to establish automatically.
H1: Plug-in the transmitter H1 to one of your any HDMI video sources, then connect the USB male port into a USB power source and wait for wireless screen mirroring/ extension to establish automatically. -
Stop and restart:
C1: Unplugging the C1 transmitter from the USB-C port to stop screen mirroring/extension, and plugging the C1 transmitter back into the USB-C port to restart.
H1: Unplugging the H1′ USB power port from the power source to stop screen mirroring/extension, and plugging the H1’s USB power back into the power source to restart.
FCC
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipment generates, uses and can radiateradio frequency energy and, if not installed and used in accordance with the instructions, maycause harmful interference to radio communications. However, there is no guarantee thatinterference will not occur in a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined by turning the equipmentoff and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution : Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1)This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 0cm between the radiator and your body
www.minix.com.hk
www.theminixforum.com