DIECAST MASTER 2AUJF-22003 Brick Blocks RC Big Foot Truck Instructions

DIECAST MASTER 2AUJF-22003 Brick Blocks RC Big Foot Truck

Battery Installation

1. Unscrew and open the controller battery cover, install 2 AAA batteries and please pay attention to the correct polarity direction, then screw the battery cover.
   

2. Please charge the car battery pack before using, connect the car battery with mobile phone charger or power bank by USB cable(Charging equipment above 2A is not recommended). The USB red light will be on when charging and be off after full charged. The charging time is about 3 hours.

3. Unscrew and open the car battery cover, connect the 7.4V Li-po batter into the plug and screw the battery cover.

4. 2.4G frequency connection: Turn on the power swift on the controller and the car, the indication light will be flickering, and when the indication light is off the frequency connection is successful.

5. Functions: forward, backward, turn left, turn right, Remote control distance: <30 meters

6. The car will enter sleep mode if no operation after 2 minutes, restart needs to press any direction key. Please turn off the controller and car power if it ‘s not played for a long time.
   

Battery Precaution

1. The 7.4V rechargeable battery pack must be charged before use by utilizing the battery charger which included.
2. Do not overcharge the battery pack. Do not charge for more than 6 hours.
3. Do not charge the battery pack if it shows leakage, corrosion, or has loose or exposed wires or other damage.
4. Do not cover the battery pack with any sort of materials while charging.
5. Do not touch the battery pack when it is hot. Wait until the battery pack cools before installing it in the Vehicle and before recharging.
6. Do not dispose of the battery in fire.
7. Do not dismantle the battery or charger, and do not cut the battery or charger cables.
8. The battery pack will be warm after charging, and hot after use in a vehicle.
9. The supply terminals are not to be short-circuited.
10. Rechargeable batteries are to be removed from the toy before being charged.
11. Rechargeable batteries for adult charging only.
12. Battery replacement must be only made by adults.
13. The transformer (charger) is not a toy.
14. Charge only type (500mAh Max.) rechargeable battery packs. Other types of batteries may burst causing injury to persons and damage. This pawer unit is intended to be correctly orientated in a vertical or floor mount position. This charger is intended to be used for charging 7.4V rechargeable battery pack with capacity 500mAh Max. It cannot be used for charging non-rechargeable batteries. Regular examination of battery charger for any damage to their cord. plug, enclosure and other parts, and that, in the event of such damage, it must not be used with the charger or battery pack charge until such damage has been repaired. Note that the AAA  batteries is non-rechargeable and is not to be recharged. Only batteries of the same or equivalent type as recommended are to be used, It will need replacement when transmission is poor.
15. Exhausted batteries are to be removed from the product.

Charging the Rechargeable Battery Pack for the vehicle

1. Connect the 7.4V rechargeable battery pack to the battery charger.
2. Plug the USB charger into the USB port.
3. The charging time for a full charge is about 3 hours.
4. When charging is completed, unplug the USB charger from the USB port.
5. Disconnect the rechargeable battery pack form the battery charger.
6. The battery charger used with the electric toy shall be regularly examined for damage to the supply cord, plug, enclosure or other parts, and in the event of damage, it shall not be used until the damage has been repaired.

START TO PLAY

To Match the signal of the Vehicle and Transmitter

1. Make sure the Vehicle and Transmitter are installed with batteries. 1. Switch ON the Vehicle.
2. Switch ON the Vehicle.
3. Switch ON the Transmitter.
4. If the vehicle does not run in straight line, adjust the Direction Adjustment on the vehicle chassis.
5. Play on smooth surface to have the optimum performance.
6. If the Vehicle is matched with more than one Transmitter, or more than one Vehicles are matched with one Transmitter. Just repeat the matching procedures and make sure only one Vehicle and one Transmitter is switched ON in the signal matching process.

How to Play

1. Switch ON the Vehicle.
2. Switch ON the Vehicle.
3. The indication light will be flickering, and when the indication light is off the frequency connection is successful.
4. Use the Left/ Right joystick to control the Vehicle turning left or right.
5. Play on smooth surface to have the optimum performance.
6. Remember to switch OFF the power of the Vehicle and Transmitter after playing.
7. The optimum control range is up to 25m outdoor.

Performance Tips

1. Do not drive on dirt, sand, dusts or go through water

2. Do not drive in windy or rainy weather Cautions

3. Avoid direct impart the Vehicles with obstacles 1. Do not attempt to disassemble the Vehicle or Transmitter

4. Switch OFF the power when not in use to prevent damage of Vehicle and Transmitter due ta leakage of electrolyte from batteries

5. Remove all batteries from the Vehicle and Transmitter when not in use for long period 3. Remove the package and take out all accessories before giving the Vehicle and

6. Keep fingers, hair and loose clothing away from wheels, built, skis Transmitter to child to play

7. The operating range can be affected by a variety of factors

   • a) Low Voltage of batteries in Transmitter or Vehicle The packaging and instruction manual contain important information, Please keep them for future reference.
   • b) Interference from ether items that emit radio frequency signals

8. Outdoor usage is recommended in order to gel optimum control range
   Warning! Choking Hazard, Not suitable far children’s under the age of 3 years due to small parts

9. Recommend to play the vehicle on a dean and smooth surface We reserve the right to improve/amend specifications and colors without notice,

10. Glean the battery compartment to make sure it is free from dust to prevent poor contact of batteries

Cautions

1. Avoid direct impart the Vehicle with obstacles 1. Do not attempt to disassemble the Vehicle or Transmitter
2. Make sure the batteries are installed with correct polarities ( +/-) as shown inside the battery compartment
3. Remove the package and take out all accessories before giving the Vehicle and Transmitter to child to play

The packaging and instruction manual contain important information, Please keep them for future reference.
Warning! Choking Hazard, Not suitable far children’s under the age of 3 years due to small parts.
We reserve the right to improve/amend specifications and colors without notice,

FCC label compliance statement:

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determines by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
   • Reorient or relocate the receiving antenna.
   • Increase the separation between the equipment and receiver.
   • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
   • Consult the dealer or an experienced radio/TV technician for help.
     Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the use~s authority to operate the equipment.
     Responsible party (contact for FCC matters only): Diecast Masters 12717 W Sunrise Blvd #418 Sunrise, FL 33323 +1 954-473-2201

RSS-210 Compliance Statement:

This device complies with Industry Canada Licence-exempt RSS-210. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada,. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotopically radiated power (e.i.r.p.) is not more than that necessary for successful communication.

Declaration of Conformity

The product is in conformity with the requirement of EU Directive 2014/53/EU.

Frequency band : 2405 – 2475 MHz
Maximum radio frequency power transmitted :<O dBm

Do not mix old and new batteries.
Environmental notes:
or rechargeable batteries.
CAN ICES-003 (B)/NMB-003(8)

Environmental notes:

The whole product also does not belong to household waste at the end of the product life. You can return it at collection points for the recycling of electronic and electronical instruments The symbol on the item, instruction manual, hangtag or packing is showing this clearly. Materials should be recycled according to their respective markings. Recycling of old devices or other re-use of materials contained therein represents an important contribution to environmental protection.
Please ask at your local community for the correct collection point.

Disposal of batteries

Batteries should not be disposed of in the household waste. As the consumer you are legally obliged to return batteries containing harmful substances and all other used batteries. You can hand in your old batteries at public collection points in your area or wherever batteries are sold.
You will find these chemical abbreviations along with a crossed-out refuse bin on batteries containing harmful substances:
Pb =Battery contains lead
Cd =Battery contains cadmium
Hg =Battery contains mercury

FCC STATEMENT

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received , including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception , which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit di1ferent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.

RF Exposure Information
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Conforms to the safety requirements of ASTM F963

CUSTOMER SUPORT

www.diecastmasters.com
©2024 Diecast Masters Company Limited
Room 1801-5, 18/F King Palace Plaza
52A Sha Tsui RoadTsuenWan, N.T., Hong Kong
• Please retain this address for future reference
MADE IN CHINA

Documents / Resources

| DIECAST MASTER 2AUJF-22003 Brick Blocks RC Big Foot Truck [pdf] Instructions
2AUJF-22003, 2AUJF22003, 22003, 2AUJF-22003 Brick Blocks RC Big Foot Truck, 2AUJF-22003, Brick Blocks RC Big Foot Truck, Blocks RC Big Foot Truck, Big Foot Truck, Foot Truck, Truck
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>