OneOdio SuperEQ V16 Bluetooth Headset User Manual
- July 22, 2024
- OneOdio
Table of Contents
OneOdio SuperEQ V16 Bluetooth Headset
Attachment List
Technical Specifications
-
Product Model: V16
Bluetooth Version: V5.3 -
Impedance : 32Q÷10%
-
Charging Time: About 6 hours
-
Playing Time : 90 hours
-
Bluetooth Range: 10m/33ft
-
Driver Diameter: 40mm
-
Net Weight: 197g
-
Frequency Response: 20Hz-20kHz
-
Sensitivity : 903dB
Function Introduction
LED Indicator Light
- Pairing: White light flashing rapidly
- Paired: White light flashing slowly
- Charging: Red light on
- Charged: Red light off
Bluetooth Pairing
- Keep the Bluetooth headset and phone (or other connected devices) within 1 meter (3 ft.) of each other; the closer the distance, the easier the pairing.
- To initiate the pairing mode, press and hold the MFB until the white light flashes rapidly.
- Activate the Bluetooth function on your phone (or other device) and perform a search for devices. Select “V16” from the list of available devices. The white light will change to a slow flash once pairing is successful.
- Bluetooth automatic reconnection:
- After initial pairing, the headset will automatically connect to the last connected device when turned on.
- Once Bluetooth is connected successfully, if you go beyond the effective range but return within 5 minutes, the headset will automatically reconnect.
Multi-point Connection
To connect the wireless Bluetooth headset to two devices simultaneously,
please refer to the pairing mode steps first. Then turn off the Bluetooth on
the connected device and repeat the pairing steps on the second device. After
successfully connecting to the second device, turn on the Bluetooth on the
first device. At this point, both devices will be connected to the headset.
Charging the Headset
-
Connect the Type-C charging cable provided with the headset to the charger.
-
The indicator light will turn red during charging.
-
Once the headset is fully charged, the red indicator light will turn off.
Disconnect the charger from the power outlet. -
Use only chargers approved by OneOdio. Unauthorized or non-company chargers may damage the headset or, in extreme conditions, cause explosions, or may void the product warranties.
-
Repeated charging and discharging of the headset will lead to a decrease in battery performance over time, which is a normal occurrence for all rechargeable batteries.
Safety Precautions
- This product is not a toy. Children should use the headset only under adult supervision.
- Do not place the device in environments that are too hot or too cold (below 0°C/32°F or above 45°C/113°F).
- Keep the device’s indicator light away from the eyes of children or animals.
- To prevent hearing damage, avoid using the headset for long periods at high volumes for extended periods of time.
- For your safety, please be mindful of traffic conditions when using the headset while driving or walking.
- To avoid interference with a pacemaker, do not wear or place the headset within 10 cm (4 in.) of the device.
- Do not use Bluetooth devices during thunderstorms, as they can cause the device to malfunction and increase the risk of electric shock.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure statement.
The device can be used in portable exposure condition without restriction.
LIMITED WARRANTY
Our friendly customer service team is ready and waiting to help. Here is how we can connect:
Global : oneodio.com/pages/support
Japan : oneodio.jp/pages/support
India : oneodio.in/pages/support
Global: +852 6940 3848 (Mon to Fri 9:00 am-6:30 pm, UTC +8 HKT)
India: +91 8929369620 9:00 to 17:30 active time (IST, Monday to Saturday)
info@oneodio.com
Manufacturer : DONGGUAN BEEVO INDUSTRIAL CO., LTD
ADD.: No.1, Jinlong Road, Jinyuling Industrial Zone Sangyuan,
Dongcheng District Dongguan China
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>