MASiMO Patient Monitoring Device User Guide

Table of Contents

Specifications

Patient Cable Connector: Allows connection to a patient cable or sensor.
Display and Touchscreen: Provides a user interface to monitor measured values and viewed alarm settings.
Backward Navigation: Provides the ability to navigate backward or exit a menu item.
DC Input Connector: Provides a connection to an AC power supply for battery charging.
Main Menu: Provides access to user settings.
Home Button: Allows for navigation back to the home screen.
Speaker: Provides audio instructions/alarms. Do not cover the speaker.

Device Setup

Plug the AC power supply into an AC outlet.
Press and hold the Power Button for more than two (2) seconds until one (1) audible tone sounds.
Insert the patient cable and secure it in place with a latch.

Sensor Selection and Placement

For the Multisite Reusable Sensor:

Wrap-around style sensor available in two sizes: Neonatal/Adult (40kg) and infant (3-20kg)
The Emitter (red light) should be aligned directly across from the Detector.
The emitter should be placed on the nail or top of the foot, and Detector on the fleshy pad of the finger or bottom of the foot.

Operation

Alarm Acknowledgement: Displays active alarms and allows silencing of active alarms.
Waveform: Displays continuous pleth waveform and signal confidence.
Parameter Display: Displays the current measured value for Oxygen SpO % and Pulse Rate PR.
Battery Indicator (24hrs of use): Shows battery charge level.
Main Menu: Adjust alarm volume, and brightness, and set date, and time.
Active Alarms: Indicates alarm priority levels.

Troubleshooting Guide

Message on Device: No Cable

Action:

Message on Device: No Sensor

Action:

Plug the AC power supply into an AC power source. Plug the DC output connector to the bottom of the Rad-G®.
Press and hold the Power Button for more than two (2) seconds until one (1) audible tone sounds.
Insert the patient cable and secure it in place with a latch.

The most appropriate sensor will depend on the size of the user. See the sensor package for recommendations.

Connect the sensor to the patient cable
Multisite Reusable Sensor (>1kg)
Wrap-around style sensor available in two sizes: > Neonatal/Adult (<3kg or >40kg) and infant (3-20kg)
The weight range for sensor size is approximate. The most important part of sensor placement is that the Emitter (red light) is aligned directly across from the Detector.
The Emitter should always be placed on the nail or top of the foot and the Detector on the fleshy pad of the finger or bottom of the foot.

MASiMO-Patient-Monitoring-Device-FIG-8

MASiMO-Patient-Monitoring-Device-FIG-9

Sensor Lifespan – Two (2) weeks with continuous use
Cable Lifespan – Two (2) years with continuous use

To clean the surface of the Rad-G® first disconnect from AC power and turn off the device.
70% Isopropyl Alcohol (IPA)
Glutaraldehyde (Cidex® Plus)
0.5% sodium hypochlorite water solution (10% bleach/water solution)
Accelerated Hydrogen Peroxide® solutions (Oxivir® TB)
Quaternary ammonium chloride solution (Up to 55% alcohol/0.5% quaternary ammonium chloride, such as Ecolab Asepti-Wipe® II Germicidal Wipes)
Do not use undiluted bleach or any solution not listed to prevent damage to the device.

References

Disclaimer

This information is provided to you for educational purposes only and should not at any time be considered a substitute for professional advice from your physician or other qualified healthcare professional.
The VEP does not assume any responsibility for the application of the content of this document or for any information that may be present in the documents or websites cited as a reference.
These references are provided for informational purposes only and do not represent VEP endorsement of any company or product.
Always consult your physician and/or a qualified healthcare professional to learn more about recommendations specific to your health needs.
640 Cataraqui Woods Drive Unit 6 Kingston, ON K7P 2Y5
Tel:613-548-6156 Toll-Free in Ontario: 1-800-633-8977 Fax: 613-548-6157
General Email:vep@kingstonhsc.ca
Web:www.ontvep.ca.
Masimo® Rad-G® Quick Start Guide
©2024 Ontario Ventilator Equipment Pool. All rights reserved.
Date of Issue: 2022-10-19. Rev. 2024-02-13.
Questions?
Call us during business hours Mon-Fri 8:30 am-4:30 pm to speak with a Registered Respiratory Therapist at 1-800-633-8977
Visit our website for more information www.ontvep.ca