FLEX SERIES
Quick Start Guide

FLEX-S Rail Camera Collins

FLEX SERIES Camera
ANTENNA & GASKET
CHARGING CABLE FLEX-S only
2 SIM CARDS
Preactivated and inserted (do not remove)
INSTALLATION STRAP
REQUIRED (sold separately)
MEMORY CARD 2 to 512 GB class 10 ultra-highspeed new microSD card
8 AA
Lithium non-rechargeable  recommended (Optional for the FLEX-S) FLEX-PLUS 8 or 16 AA
OR
LIT-22
Rechargeablelithium battery pack
(Optional for the FLEX-S) FLEX PLUS 1x or 2x LIT-22

BEFORE YOU GO TO THE FIELD

Getting ready, first time use
flex-s only
#1  Charge the internal battery.
While the camera is off, plug the 12Vdc connector (charging cable) to the camera. The status light will illuminate red while charging and turn off when fully charged. It is recommended to charge the battery fully (approximately 12 hours).

2 Create an account on spypoint.com/activate

3 Download the SPYPOINT app and sign in. #4 In the Cameras tab, press the

button.
Follow the instructions on the screen to add your camera. #5 Screw in antenna & insert memory card, batteries.
 Insert the tray(s) following the arrow orientation. #6 Turn your camera ON.
All LEDs will begin to blink. #7 Format your memory card.
Immediately hold down the format button until the FORMAT LED blinks green. Format is complete when LED stops blinking. #8 Press the TEST button to receive a photo.

9 Turn your camera OFF until you’re ready to install it in field.

IN THE FIELD

XX #10 flex-s only
Install your camera in a location where the solar panel will receive at least 4 hours of direct sunlight.
Tips Use: Installation strap
Orientation: North or South
Height: Subject’s mid-body
Lens sight: No leaves, branchesor tall grass in front
#11 Turn your camera
ON & test it. (Steps 6 & 8)

COMPONENTS

¼”-20 tripod mount
21| Battery door
22| microSD card slot
23| Micro SIM card slots
24| Battery tray
25| Solar Panel

References

• Spypoint

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>