SOUTHERN SALMON LIGHTS SSL-0200-00-10-0000 Aquaculture LED Lights Instruction Manual

Table of Contents

Specifications

Installing Units

Use eye bolts to secure the unit with a support system, ensuring no weight on the supply cable.
Avoid pulling the unit up by the supply cable.
Ensure the water flows past the light fitting at all times; water temperature should not exceed 20 degrees.
Avoid chemicals in water where the fitting is used.
Do not open the fitting under any circumstances.
Clean with water and a soft cloth only, avoid chemicals or brushes.
If the LED lamp stops working, report using the serial number without attempting to remove the bolts.
Contact the website or use QR code for further assistance.
Do not operate the unit outside of water to prevent overheating.
Avoid pulling on the supply cable and handle it with care.
Do not open the unit for any reason.

All certifications are available on the website using the QR code provided.

Q: Can I use chemicals to clean the unit?
A: No, clean only with water and a soft cloth to avoid damage.
Q: What should I do if the LED lamp stops working?
A: Do not attempt to remove bolts. Report the issue by quoting the serial number and contacting support for assistance.
Q: Can I operate the unit outside of water?
A: No, energizing the unit outside of water can cause overheating, always ensure it is submerged when in use.

When unboxing the units check that all units are in good condition
Before installing, check that all bolts are still on 4 N.m (Newton meter torque)
Also check that the black grommet on the top of the unit is tightened
The reason for this is, that the bolts and grommet can be shaken loose during transport
Scan the QR code for all additional information

Installing units

Use the two eye bolts to fasten the unit with support (Rope or any support system) so that there is no weight carried by the supply cable

SOUTHERN-SALMON-LIGHTS-SSL-0200-00-10-0000-Aquaculture-LED-Lights-
fig-1

Under no circumstances pull the unit up on its supply cable, always use the support
The light fitting must have water flowing past it at all times when operating
Water temperature can not exceed 20 degrees. If more it will damage the light fitting
No chemicals must be present in the water that the fitting is being used in
The fitting must not be opened for any reason

Clean only with water and a soft cloth, never use chemicals or any type of brush on the cylinder
If the led lamp stops working, do not attempt to remove any bolts on the unit. Report the unit by quoting the serial number (The yellow tag on the end of the lead example (SSL-0200-00-10-0000)
Visit the website www.southernsalmonlights.com and send us an email or use the QR code

Warnings

Certification

Contact

Read User Manual Online (PDF format)