ETHIRTEEN CG32 Vario Chain User Manual

ETHIRTEEN CG32 Vario Chain User Manual

Trail 2-Bolt
Add multiple spacers for required chain line. See box info.

Endure
Add multiple spacers for required chain line. See box info.

**36T Max Direct Mount Bash guard

32T Max Direct Mount Bash guard**

Downhill
Add multiple spacers for required chain line. See box info.

32T Max Direct Mount Bash guard

Bottom only
Add multiple spacers for required chain line. See box info.

32T Max Direct Mount Bash guard

Tighten all bolts at installation to required torque!

• Install back plate spacers per chain line and ISCG-05 tab offset requirements.
• When combined spacer thickness is 3mm or more, use 15mm bolts.

DARIO CHAIN GUIDE USER MANUAL

UPPER ARMATURE POSITION LOWER ARMATURE POSITION

Narrow chain lines and wide ISCG tabs may require moving the upper armature inboard of the back plate.

LOWER ARMATURE POSITION

NARROW POSITION (NORMAL)

WIDE POSITION (BIKES WITH DROPPED CHAINSTAYS)

VERTICAL ADJUSTMENT

1. LOOSEN T25 Torx screw
2. MOVE window to correct tooth count
3. TIGHTEN T25 Torx screw to 6Nm
   Make sure 0.5mm washer is installed

HORIZONTAL ADJUSTMENT

1. LOOSEN 3mm HEX set screw inside the T25 Torx screw
2. ALIGN slider with chainring
3. TIGHTEN 3mm HEX set screw to 3Nm

FULL COVERAGE CLOCKING

NO SAG & CHAIN ON SMALLEST COG

ULTRA COMPACT CLOCKING

CHAIN AND BOTTOM OF SLIDER PARALLEL AT SAG

UPPER GUIDE REMOVAL

1. LOOSEN inside 3mm HEX set screw
2. MOVE chain guide block outwards
3. ROTATE block clockwise to front
4. SLIDE guide off the pin

LOWER SLIDER – CHAIN TENSION

1. LOOSEN T25 Torx screw
2. POSITION the lower slider: Arrow below chain.
3. TIGHTEN T25 Torx screw to 1Nm

TORQUE SPEC

FOR MORE INFORMATION, VISIT WWW.ETHIRTEEN.COM/SUPPORT

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>