TECH CONTROLLERS EU-ML-4X WiFi Floor Heating Controllers User Manual
- July 13, 2024
- TECH CONTROLLERS
Table of Contents
- TECH CONTROLLERS EU-ML-4X WiFi Floor Heating Controllers
- Specifications
- Product Description
- Installation
- SAFETY
- TECHNICAL DATA
- UE DECLARATION OF CONFORMITY
- DEVICE DESCRIPTION
- INSTALLATION
- Connection of the EU-ML-4X WiFi module with the EU-L-4X WiFi controller
- Connection of actuators to the EU-ML-4X WiFi module
- Example installation diagram
- WARRANTY CARD
- FAQ
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
TECH CONTROLLERS EU-ML-4X WiFi Floor Heating Controllers
Specifications
- Power supply: AC 230V, 50Hz
- Ambient working temperature: Not specified
- Potential contacts: 5-8 maximum output load
- Fuse: Not specified
Product Description
The EU-ML-4X WiFi floor heating extension module is designed to operate with the EU-L-4X WiFi controller. It allows for an extension of the floor heating system through the addition of 4 zones via the use of either wireless sensors and controllers, or the wired RS-485 (TECH SBUS) controllers connected to/registered with the EU-L-4X WiFi controller. It employs thermoelectric actuators, e.g. STT-230/2 T, STT-230/2 M.
Devices for the expansion of the system are updated on an ongoing basis on our website www.tech-controllers.com
Installation
Connection of the EU-ML-4X WiFi module with the EU-L-4X WiFi controller
Follow the provided instructions to connect the EU-ML-4X WiFi module with the EU-L-4X WiFi controller.
Connection of actuators to the EU-ML-4X WiFi module
Connect the thermoelectric actuators to the EU-ML-4X WiFi module as per the example installation diagram provided in the user manual.
SAFETY
Before using the device for the fi rst time the user should read the following
regulations carefully. Not obeying the rules included in this manual may lead
to personal injuries or controller damage. The user’s manual should be stored
in a safe place for further reference. In order to avoid accidents and errors
it should be ensured that every person using the device has familiarized
themselves with the principle of operation as well as security functions of
the controller. If the device is to be sold or put in a diff erent place, make
sure that the user’s manual is there with the device so that any potential
user has access to essential information about the device.
The manufacturer does not accept responsibility for any injuries or damage
resulting from negligence; therefore, users are obliged to take the necessary
safety measures listed in this manual to protect their lives and property.
WARNING
- High voltage! Make sure the regulator is disconnected from the mains before performing any activities involving the power supply (plugging cables, installing the device, etc.).
- The device should not be operated by children.
TECHNICAL DATA
We are committed to protecting the environment. Manufacturing electronic devices imposes an obligation of providing for environmentally safe disposal of used electronic components and devices. Hence, we have been entered into a register kept by the Inspection For Environmental Protection. The crossed-out bin symbol on a product means that the product may not be disposed of to household waste containers. Recycling of wastes helps to protect the environment. The user is obliged to transfer their used equipment to a collection point where all electric and electronic components.
UE DECLARATION OF CONFORMITY
Hereby, we declare under our sole responsibility that EU-ML-4X WiFi manufactured by TECH STEROWNIKI II Sp. z o.o., head-quartered in Wieprz Biała Droga 31, 34-122 Wieprz, is compliant with Directive 2014/35/EU of the European Parliament and of the Council of 26 February 2014 on the harmonisation of the laws of Member States relating to the making available on the market of electrical equipment designed for use within certain voltage limits (EU OJ L 96, of 29.03.2014, p. 357), Directive 2014/30/EU of the European Parliament and of the Council of 26 February 2014 on the harmonisation of the laws of Member States relating to electromagnetic compatibility (EU OJ L 96 of 29.03.2014, p.79), Directive 2009/125/EC establishing a framework for the setting of ecodesign requirements for energy- related products as well as the regulation by the MINISTRY OF ENTREPRENEURSHIP AND TECHNOLOGY of 24 June 2019 amending the regulation concerning the essential requirements as regards the restriction of the use of certain hazardous substances in electrical and electronic equipment, implementing provisions of Directive (EU) 2017/2102 of the European Parliament and of the Council of 15 November 2017 amending Directive 2011/65/EU on the restriction of the use of certain hazardous substances in electrical and electronic equipment (OJ L 305, 21.11.2017, p. 8).
For compliance assessment, harmonized standards were used: PN-EN IEC
60730-2-9:2019-06, PN-EN 60730-1:2016-10, PN EN IEC 63000:2019-01 RoHS.
Wieprz, 05.03.2024
DEVICE DESCRIPTION
The EU-ML-4X WiFi floor heating extension module is designed to operate with
the EU-L-4X WiFi controller.
It allows for an extension of the floor heating system through the addition of
4 zones via the use of either wireless sensors and controllers, or the wired
RS-485 (TECH SBUS) controllers connected to/registered with the EU-L-4X WiFi
controller.
It employs thermoelectric actuators, e.g. STT-230/2 T, STT-230/2 M.
Devices for the expansion of the system are updated on an ongoing basis on our website www.tech-controllers.com
INSTALLATION
WARNING
- The module should be installed by a qualified person.
- Risk of fatal electric shock from touching live connections. Before working on the controller switch off the power supply and prevent it from being accidentally switched on.
- Incorrect connection of wires may damage the controller.
Connection of the EU-ML-4X WiFi module with the EU-L-4X WiFi controller
Connection of actuators to the EU-ML-4X WiFi module
Example installation diagram
WARRANTY CARD
TECH STEROWNIKI II Sp. z o.o. company ensures the Buyer proper operation of
the device for the period of 24 months from the date of sale. The Guarantor
undertakes to repair the device free of charge if the defects occurred through
the manufacturer’s fault. The device should be delivered to its manufacturer.
Principles of conduct in the case of a complaint are determined by the Act on
specific terms and conditions of consumer sale and amendments of the Civil
Code (Journal of Laws of 5 September 2002).
CAUTION! THE TEMPERATURE SENSOR CANNOT BE IMMERSED IN ANY LIQUID (OIL ETC.).
THIS MAY RESULT IN DAMAGING THE CONTROLLER AND LOSS OF WARRANTY! THE
ACCEPTABLE RELATIVE HUMIDITY OF THE CONTROLLER’S ENVIRONMENT IS 5÷85% REL.H.
WITHOUT THE STEAM CONDENSATION EFFECT.
THE DEVICE IS NOT INTENDED TO BE OPERATED BY CHILDREN.
Activities related to setting and regulation of the controller parameters
described in the Instruction Manual and parts wearing out during normal
operation, such as fuses, are not covered by warranty repairs. The warranty
does not cover damages arising as a result of improper operation or through
the user’s fault, mechanical damage, or damage created as a result of fi re,
flood, atmospheric discharges, overvoltage, or short-circuit. The interference
of an unauthorized service, wilful repairs, modifications, and construction
changes cause the loss of Warranty. TECH controllers have protective seals.
Removing a seal results in the loss of Warranty.
The costs of unjustifiable service call to a defect will be borne exclusively
by the buyer. The unjustifiable service call is defined as a call to remove
damages not resulting from the Guarantor’s fault as well as a call considered
unjustifiable by the service after diagnosing the device (e.g. damage of the
equipment through the fault of the client or not subject to Warranty), or if
the device defect occurred for reasons lying beyond the device.
To execute the rights arising from this Warranty, the user is obliged, at his
own cost and risk, to deliver the device to the Guarantor along with a correct
filled-in warranty card (containing, in particular, the sale date, the
seller’s signature and a description of the defect) and sales proof (receipt,
VAT invoice, etc.). The Warranty Card is the only basis for repair free of
charge. The complaint repair time is 14 days.
When the Warranty Card is lost or damaged, the manufacturer does not issue a
duplicate.
FAQ
Q: Can I use wireless sensors with this product?
A: Yes, the EU-ML-4X WiFi module supports the use of wireless sensors for extending the floor heating system.
Q: What should I do if the device is damaged by lightning?
A: Ensure that the plug is disconnected from the power supply during a storm to prevent damage by lightning strikes.