FISHER and PAYKEL 431059B Contemporary Square Fine Handle Installation Guide

Table of Contents

FISHER-and-PAYKEL-431059B-Contemporary-Square-Fine-Handle-
PRODUCT

Specifications

Accessory: Handles
Supplied Components: Handle (1), M5x25mm countersunk screw (2) for Dishdrawer panels, M5x25mm pan head screw (2) for Custom and Dishwasher panels
Tools Required (Not supplied): Powered driver, Crosshead driver, Tape measure, Level

Mark the handle location on the panel ensuring the distance between holes is 432mm.
Align the handle with the pin holes at the front of the panel (custom or supplied).
Drill the holes using a 6mm drill bit.
Counterbore to a maximum depth of 5mm from the back of the panel.
Align the handle with the pin holes at the front of the panel. Insert the supplied pan head screws from the rear of the panel.
Secure the handle by tightening the screws using a crosshead driver.
Follow the instructions in the install guide to attach the custom panel to the drawer or dishwasher using countersunk screws.

Q: What tools are required for fitting handles to panels?
A: You will need a powered driver, crosshead driver, tape measure, and a level for fitting handles to panels.
Q: What is the distance between holes when marking the handle location on the panel?
A: The distance between holes should be 432mm when marking the handle location on the panel.
Q: How deep should you counterbore when fitting handles to pre-finished panels?
A: Counterbore to a maximum depth of 5mm from the back of the panel when fitting handles to pre-finished panels.

WARNING!
Cut Hazard
Failure to use caution could result in injury.

Take care: some edges may be sharp.
For products that are not front-mounted, installation must be carried out by a Fisher & Paykel trained and supported service technician.
Ensure all packaging is removed and disposed of responsibly.
Installation of this product requires basic mechanical skills.
Ensure the product is installed with the correct tools to avoid personal injury or damage to the appliance.
Take care not to scratch the door with the supplied Hex key when tightening the screws.

Supplied

Not supplied

CUSTOM PANELS

Mark the handle location on the panel. Ensure the distance between holes is 432mm.
Drill the holes using a 6mm drill bit.
Counterbore to a maximum depth of 5mm from the back of the panel
Align the handle with the pin holes at the front of the panel.
Insert the supplied pan head screws from the rear of the panel.
Secure the handle by tightening the screws using a crosshead driver.
Follow the instructions in the install guide to attach the custom panel to the drawer or dishwasher.

PRE-FINISHED PANELS

Align the handle with the pin holes at the front of the panel (custom or supplied).
Insert the supplied screws from the rear of the panel.
Secure the handle by tightening the screws using a crosshead driver.
- For custom and Dishwasher panels, use panhead screws.
- For Dishdrawer panels, use countersunk screws.

For more information, visit www.fisherpaykel.com.