STA BREEZE 12V – 650W Hybrid Charge Controller User Manual
- July 13, 2024
- STA BREEZE
Table of Contents
STA BREEZE 12V – 650W Hybrid Charge Controller
Product Information
Specifications
- Model: 1HZ
- Type: *HQHUDWLRQ
- Power: 1HXH
- Features: User-friendly interface, durable design
Product Usage Instructions
New Generation
650W-850W HYBRID CONTROLLER USER MANUAL
WARNING:
The controller is just for battery charging. It can only directly connect to
battery. Please note that + and – poles when the battery is connected. Connect
in the same directions. You should never connect directly to any other devices
such as inverters. In case of incorrect connection, devices may pose risk of
re-hazard.
DESCRIPTION:
This controller combines the functions of AC to DC rectifer and wind turbine
controller. It is the most cost effective solution for renewable energy
systems. The controller is suitable for wind turbines with permanent magnet
generator or hydro system with permanent magnet generators, which has a
3-phase AC output within the corresponding voltage range. This controller is
suitable for use with 150W Solar PV. It recties and regulates the generator’s
3 phase alternating current in order to be able to charge battery banks in a
smooth and safe way the also protects the batteries from over-charging. When
the battery has reached fully charge state, it will cut of current flowing to
the battery and brake the wind turbine automatically.
FEATURES:
Great for wind system controller can support battery charging from
simultaneous wind generator load up to 500 watt or 700 watt. It can use
togetheruntil 150W solar PV.
Load control and diversion control: the controller has over charge protection, short circuit protection, pole confusion protection. It is reliable with highly eficient, long services life.
Light’s Meaning
- RED: When red light is on it mean’s brake system work (Battery Discharge)
- ORANGE: When orange light is on it mean’s controller work (Battery Charge Mode)
SPECIFICATION
INSTALLATION:
The controller is designed to be mounted on a vertical wall
-
Step 1:
Connect the device as shown in battery, the battery cable connection, use a minimum thickness of 6mm². Please attention when you connect terminals, If connecting like +/+ and rigth, your controller will burn and it out of warranty. -
Step 2:
3 connect the cable from the devices as shown in the wind turbine. (this 3-cable connection sequence is not important.) When start to installation be careful +/- pole, Connect cable comes from Solar PV what is shown on devices.
Now connect the solar system, please adjust to connect the negative pole to negative pole and positive pole to positive pole.
Battery and Turbine installation with controller
Powering On the Device
To power on the device, locate the power button and press it for a few seconds
until the screen lights up.
Navigating the Interface
Use the navigation buttons to move through different menus and options. The
user-friendly interface allows for easy navigation.
Adjusting Settings
Access the settings menu to customize various features according to your
preferences. Follow the on-screen instructions to make changes.
Maintenance and Care
Regularly clean the device with a soft, dry cloth to prevent dust
accumulation. Avoid exposing the device to extreme temperatures or moisture.
Wiring diagram for an example
That’s it. Installation is finished
Frequently Asked Questions
Q: How do I reset the device to factory settings?
A: To reset the device, navigate to the settings menu, select “Reset,” and
follow the on-screen prompts.
Q: Can I use this product outdoors?
A: While the product is durable, it is recommended to avoid exposing it to
direct sunlight or rain to ensure longevity.
Q: What should I do if the device malfunctions?
A: If you encounter any issues with the device, refer to the troubleshooting
section of the user manual or contact customer support for assistance.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>