VAN ELEK VAN-W4F-3 Vantage Multi Function Wireless Charger Installation Guide
- July 8, 2024
- VAN ELEK
Table of Contents
VAN ELEK VAN-W4F-3 Vantage Multi Function Wireless Charger
ASSEMBLY INSTRUCTION
TOP MOUNTING ASSEMBLY INSTRUCTION VAN-W4F-3 in 1-01 FP +VAN-USAD-3609-F-DC +VAN-USB-A/C-CFD
-
STEP#1:
Insert plastic gourmet
-
STEP#2:
Insert 3 in 1 unit VAN-W4F-3 in 1-01 FP into prepared hole and snap into plastic gourmet
-
STEP#3:
VAN-W4F-3 in 1-01 FP +VAN-USAD-3609-F-DC+VAN-USB-A/C-CFD
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Refer to FCC Part 18.213(c) and KDB 784748 Anner A section A.5:
- Max. Electric Field Emissions: 6.26V/m
Max. Magnetic Field Emissions: 0.60A/m
(b) The maintenance of the system is the responsibility of the
manufacturer.
(c) To prevent interference, the product should be as far away from
devices operating at the same frequency as possible.
RF exposure considerations
This equipment complies with the FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and any part of your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>