TILTA TT-CT08-75-SG 75mm Cine Fluid Head with 3 Stage Carbon Fiber Tripod Legs User Manual
- July 9, 2024
- TILTA
Table of Contents
TILTA TT-CT08-75-SG 75mm Cine Fluid Head with 3 Stage Carbon Fiber
Tripod Legs
DISCLAIMER
Thank you for purchasing TILTA products.
- Before using this product, please carefully read this document to ensure that the product has been set up correctly. The final interpretation of this document and all related documents for this product belongs to TILTA. For updates, please visit the official website at www.tilta.com for the latest product information. TILTA reserves the right to modify any information in this manual at any time without prior notice and without assuming any responsibility.
- By using this product, you are deemed to have carefully read the disclaimer and warnings, understood, agreed, and accepted all the terms and content of this statement. You promise to take full responsibility for the use of this product and any consequences that may arise. You commit to using this product only for legitimate purposes and agree to these terms as well as any related regulations, policies, and guidelines set by TILTA.
- TILTA is not responsible for any damages, injuries, or legal liabilities caused directly or indirectly by the use of this product. Users should follow all safety guidelines mentioned in this document, including but not limited to those mentioned.
- Despite the above provisions, consumer rights are still protected by local laws and regulations and are not affected by this disclaimer.
- TILTA is a trademark of Shenzhen TILTA Technology Co., Ltd. and its affiliated companies. Product names, brands, and other trademarks appearing in this document are trademarks or registered trademarks of their respective companies.
SPECIFICATIONS
- [CTDB TRIPOD SYSTEM]
- Material: Aluminum Alloy + Carbon Fiber
- Weight: 4.5 KG
- Folded Size: 158 x 135.5 x 749.5 mm
- Minimum Height: 250 mm ; Maximum Height: 1800 mm
- Operating Temperature: -50°C to 60°C
- [CTDB FLUID HEAD]
- Material: Aluminum Alloy
- Weight: 2.128 KG
- Load Capacity: 8 KG
- Size: 141 x 122 x 172 mm
- Counterbalance: 8 Stops (1-8)
- Drag: 4 Stops (1-4) vertical; 4 Stops (1-4) horizontal
- Tilt Angle: -60° to +90°
- [CTDB TRIPOD LEGS]
- Material: Aluminum Alloy + Carbon Fiber
- Weight: 2.3 KG
- Tripod Legs Payload: 75 kg / 165 lbs at 22.5° (First Level) ; 12 kg / 26 lbs at 85° (Fourth Level) Folded Size: 136 x 127 x 599 mm
- Bowl Diameter: 75 mm Bowl
- Leg Diameter: 36 mm/ 32 mm/ 28 mm/ 24 mm
- Minimum Height: 92 mm ; Maximum Height: 1681 mm
- Leg Angle: 22.5° (First Level)/ 43° (Second Level)/ 63° (Third Level)/ 85° (Fourth Level) Special Features: High-strength carbon fiber single tube, buckle-type locking.
- UICK RELEASE PLATE TYPE]
- Arca-Swiss/ Manfrotto Dual Quick Release Plate
- [RECEIVING PLATFORM]
- Arca-Swiss/ Manfrotto Dual Receiver (Adjustable front to back, the platform can be removed
FLUID HEAD /TRIPOD
FLUID HEAD – INTRODUCTION
VERTICAL DRAG ADJUSTMENT/
FLUID HEAD – INTRODUCTION (2)
ADJUSTABLE FRONT AND BACK FOR BALANCE ADJUSTMENT
FLUID HEAD – INTRODUCTION
RECEIVING PLATFORM CAN BE REPLACED WITH TILTA DOVETAIL ADAPTER (OPTIONAL)
Adjust the plate’s position, loosen the lever and remove the M3 screw 2 under the plate, then 3 remove the plate Replace with an the lever 5• 8″ Arri Dovetail Adapter Plate for Tilta Cine Tripod (TT-ADA-8-SG) or 8″ Tilta Standard Dovetail Tripod Adapter Plate (TA-TAP8-SG), slide it onto the fluid head, and tighten with
TRIPOD – INTRODUCTION
When folded, the legs can be opened directly to the first position.
When the tripod is not supporting weight, hold the angle adjustment button 1 and lift the leg 2 simultaneously to complete the angle adjustment to the second, third, or fourth stop.
EXTENDABLE LEG TUBE ADJUSTMENT
MOUNTING A CAMERA
CAUTION & WARNINGS
- Please avoid overloading the device.
- Do not operate in temperatures below -50°C or above 60°C.
- . After use in humid, muddy, or dusty environments, make sure to clean the tripod with a dry cloth. If the tripod gets wet from rain, leave it extended for a few days to let any moisture within the legs dry before folding it back up.
- Avoid prolonged exposure of the product to sunlight and prevent it from being left inside a hot car for extended hours, which can lead to overheating.
- Never leave the product unattended when in public places. Exercise caution when operating in potentially dangerous locations.
- It is strongly recommended not to carry the tripod when it is loaded with equipment (such as a camera).
- The product does not require lubricants. However, if needed, please use standard lubricating oil or grease. Chemical products ety uing is prodiu electrified objects, high-voltage equipment, or strong
TILTA 75MM CINE FLUID HEAD WITH 3-STAGE CARBON FIBER LEGS (8KG)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>