HAMPTON BAY HB40-N Dehumidifier Instruction Manual

July 5, 2024
HAMPTON BAY

HAMPTON BAY HB40-N Dehumidifier

Specifications

  • Brand: HAMPTON BAY
  • Model: HB40-N
  • Type: Dehumidifier
  • Number of Models: 59

Product Usage Instructions

Overview

INSTALLATION

WARNING

Electrical Shock Hazard

  1. Do not sean extension cord ele prig dator with this unit.
  2. Do not operate unit with front removed.

Failure to follow the above precautions could result in electrical shock, fire or personal injury If the dehumidifier has a serlal plate rating of 115 volts and up to and including 7.5 amps the unit may be on a fuse or circuit breaker with other devices. However, the maximum amps of all devices on that fuse or circuit breaker can not exceed the the locations the seria reate hat applies to this model can be found on the back page of this manual.

Notice
RECOMMENDED CIRCUIT WIRE SIZES

(As installed per building code)

  • Power Supply: 115V, 60HZ AC Only 1-Phase
  • Ouflet Requirement: 3-Prong Grounding Type 125 V, 15 Amp
  • Minimum Wire Size: #14 (A.W.G.) 3-Wire Use Copper Wire Only
  • Circuit Protector: 15 Amp Time Delay Fuse or Circuit Breaker

ELECTRICAL REQUIREMENTS

Important Grounding Requirements
Your Dehumidifier will operate on any 115 volt, 3-pronged (grounded), 60 Hz circuit. A separate line is not required, but it is advisable not to over- load the circuit with heavy duty appliances such grounding plug and must be plugged into a prop- erly grounded outlet (Figs. 1 & 2). If your outlet is not of the proper type, it is your responsibility to have the outlet and wiring changed to the correct type. DO NOT cut off the third (grounding) prong. DO NOT USE AN ADAPTER.

INSTALLATION REQUIREMENTS
This dehumidifier has been carefully engineered, manufactured and tested to give you many years of comfort and dependable operation. THIS IMPORTANT INFORMATION tells you all you need to know about installing, using and car- ing for your new Dehumidifier. Keep it handy, it will answer your questions, save you time and expense of unnecessary service calls, and insure that, as the owner of this superb appliance, you receive maximum comfort and enjoyment for many years.

Leave at Least 10″ Clearance
Your dehumidifier must be kept clear of any restrictions to air flow. Position unit at least 10″ away from walls or other obstructions (Fig. 3).

Close Windows and Doors
To assure efficient dehumidification, close all win- dows and doors in the area where the dehumidifi- er is to operate (Fig. 4).

Plug-In
staly have appropred your die, pif eh and in the dietrica recyiremens fugiet as indicated

OPERATION

CONTROL PANEL

Pictured control panel is similar to your panel. FAN SWITCH: Some dehumidifiers feature a two-speed fan. Use the high speed to maintain maximum water removal. The lower speed can be used when quieter operation is desired.

Automatic Humidity Control (on most models)
The humidistat control automatically turns your dehumidifier on or off to maintain the humidity level you select. Allow dehumidifier to reach room temperature, then turn control knob to num- ber 5 (normal average setting). If unit does not turn on at this setting, this generally means that the relative humidity is already low and dehumidi- fication may not be needed at this time. After operating several days at this setting with for higher humidity (moist air).

Special Design Prevents Freeze-up
This design will allow your dehumidifier to oper- ate as low as 65°F and 50% relative humidity without freeze-up. It features a specially designed dehumidifier coil with copper tubes mechanically bonded to full collared aluminum fins. This com- miditicationvides a superior surface area for dehu- In general, dehumidification is not usually needed during conditions of low room temperature (below 65°F) or low relative humidity. Continued opera- tion under these conditions may cause frost forma- tion on the dehumidifying coil thus blocking the air circulation. To save electricity and prevent pos- sible damage to the unit, it is best to turn the unit OFF.

Important: This water is not suitable for drinking.

FRONT PANEL

Water Disposal (with container)

  1. Prior to removal of container, turn the Humidistat Control to OFF position.
  2. The handy container fits into the bottom front of dehumidifier and collects water removed from the air. Use care so that the float rod will not be broken as the container is removed or replaced.
  3. Re-insert the container, and reset the Humidistat Control to previous setting.

(permanent drain operation without container)

  1. Unplug dehumidifier from power supply.
  2. Remove water container from dehumidifier.
  3. Use one of the supplied clips to lock bucket switcharm to sheetmetal bulkhead (Fig. 6).
  4. With the water container removed, and the dehumidifier positioned over a floor drain, water can flow directly through the opening provided in the base into the drain, OR with the water container removed, a garden hose nay be attached to permit draining the water to a remote drain. The special thread* on the drain pan will facilitate quick attachment of the hose.
  5. The bucket front cover can be placed back on the unit for aesthetic purposes. Simply press on either side of the container to release tabs. Insert the clips (supplied) into the bucket front cover as illustrated. Push this piece, with clips assembled, into opening in front of the unit as illustrated (Fig. 6).

Overflow Indicator (on most models)
An automatic overflow switch and indicator light are provided on most models to turn the dehumid- ifier off before the container overflows. When the indicator light on the control panel glows, the water container must be emptied.

Setting Up the Dehumidifier
Place the dehumidifier on a flat, stable surface near a power outlet. Ensure there is proper ventilation around the unit.

Powering On the Dehumidifier
Plug the dehumidifier into a power source and switch it on using the power button. Adjust the settings as per your requirements.

Setting Desired Humidity Levels
Use the control panel to set your desired humidity level. The dehumidifier will work to maintain this level in the room.

Emptying the Water Tank
Regularly check the water tank indicator and empty it when full to ensure optimal performance.

Only threaded half-way around.
Proper use and care of your dehumidifier will help ensure longer life of the unit. It is recommended to annually inspect and clean the coils and condensale water passages. Expense of annual inspection is the consumers responsibillity

Filter Cleaning

  1. Use a vacuum cleaner attachment or brush to clean the front grille.
  2. Remove the filter by sliding the filter up using the two recessed “finger-tip” tabs (Fig. 7).
  3. To clean the filter, wash in warm, soapy water, rinse and shake dry. Cleaning is recommended monthly, or as conditions require.
  4. For cleaning the water container, remove the top (if equipped) and wash with warm soapy water.

SERVICE & WARRANTY

Service
(Read carefully before calling for service)

If the Dehumidifier Fails to Start

  • Make sure the unit is plugged into an operat- ing outlet and the control knob is turned to the number “g” position.
  • If the indicator light (most models) is on, empty the full water container. The indicator light should now go OFF, and the dehumidifier will begin to operate so be sure to quickly reinsert the empty water container. If the dehumidifi- er does not begin to operate check the float arm to be sure it is free to operate. This is located in the water container compartment.

Unit Runs, But Very Little Water is Collected

  • The amount of water removed from the air depends on the relative humidity of the air and the capacity of the dehumidifier purchased. When the air feels damp (high relative humidity), more moisture will be removed and the container will fill up more rapidly. As the unit continues to remove moisture and reduce the humidity in the area, less water will be collected in the container.

Save Electricity and Prevent Freeze-up
In general, dehumidification is not usually needed during conditions of low room temperature (below 65°F) or low relative humidity. Continued operation under these conditions may cause frost formation on the dehumidifying coil thus blocking the air cir- culation. To save electricity and prevent pos- sible damage to the unit, it is best to turn the unit Off. Sounds

It is reassuring to know that your dehumidifier is functioning properly. These are some normal sounds which should not be a cause for concern:

  • Air rushing over air drying coils.
  • Hissing or thumping – refrigerant is flowing throughout the sealed system and may generate a “boiling” sound right after the compressor stops.
  • Compressor may “thump” as it cycles on and off.
  • Water dripping from coils onto the drain plate. The humidistat control, compressor and fan “tick” as they turn on and off. Metal makes a similar sound when expanding or contracting.

For Models Installed in North America – If Service or Parts are Required
First, make the recommended checks. If it appears that service or parts are still required, see your dehumidifier warranty “How to Obtain Warranty Service or Parts”.

For Models Installed Outside North America
For dehumidifiers purchased for use outside North America, the manufacturer does not extend any warranty either expressed or implied. Consult your local dealer for any warranty terms extended by the importer in your country.

Dehumidifier Warranty
(Within the 48 contiguous United States, state of Hawail, the District of Columbia, Puerto Rico, and Canada)

Full (One Year) Parts and Labor Warranty
During the first year after the date of original purchase, Hampton Bay will, through its authorized servicers and free of charge to the owner or any subsequent user, repair or replace any parts which are defective in material or workmanship due to normal use when the dehumidifier is delivered by the owner to and picked up from one of our authorized servicers. If requested, in- home ser- vice, pick up, redelivery and reinstallation will be provided, but are the owner’s responsibility.

Limited (Second Through Fifth Year) Sealed System Warranty
If any part of the sealed refrigerant system (consisting of compressor, evaporator, condenser, and interconnecting refrigerant tubing) should fail because of a defect in material or workmanship (including refrigerant charge), within the second through fifth year from the date of original pur- chase, Hampton Bay, through its authorized servicers, will repair or replace such part, including labor, at no cost to the owner when the dehumidifier is delivered by the owner to and picked up from one of our authorized servicers. If requested, in-home service, pick up, redelivery and reinstal- lation will be provided, but are the owner’s responsibility.

Note: In the event of any required parts replacement within the period of this warranty, Hampton Bay replace- ment parts shall be used and will be warranted only for the period remaining on the original warranty.

Exceptions
The above Limited Warranties does not cover failure to function caused by damage to the unit while in your possession (other than damage caused by defect or malfunction), or by its improper installation, or by unreasonable use of the unit, including without limitation, failure to provide reasonable and necessary maintenance or to follow the written Installation and Operating Instructions. If the unit is put to commercial, business, rental, or other use or application other than for consumer use, we make no warranties, express or implied, including but not limited to, any implied warranty of merchantability or fitness for particular use or purpose.

THE REMEDIES PROVIDED FOR IN THE ABOVE EXPRESS WARRANTY ARE THE SOLE AND EXCLUSIVE REMEDIES THEREFOR, NO OTHER EXPRESS WARRANTIES ARE MADE. ALL IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR USE OR PURPOSE, ARE LIMITED IN DURATION TO ONE YEAR FROM THE DATE OF ORIGINAL PURCHASE. IN NO EVENT SHALL HAMPTON BAY BE LIABLE FOR INDIRECT, INCIDENTAL, OR CONSE- QUENTIAL DAMAGES, EVEN IF ADVISED IN ADVANCE OF THE POSSIBILITY OF SUCH DAMAGES. NO WAR- RANTIES, EXPRESS OR IMPLIED, ARE MADE TO ANY BUYER UPON RESALE.

Some states do not allow limitations on how long an implied warranty lasts or do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. No warranties are made for units sold outside of the above stated areas. Your distributor or final seller may provide a warranty on units sold out- side of these areas.

How to Obtain Warranty Service or Parts
Service for your dehumidifier will be provided by CareCo, a division of the manufacturer with authorized independent servicers nationwide.
Note : Before calling for service, carefully read the Installation and Operating Instructions booklet.

Then if you need service:

  1. Call a CareCo authorized servicer and advise them of model number, serial number, date of purchase and nature of complaint. Service will be provided during normal working hours. Contact your dealer for the name of an authorized servicer if unknown to you.
  2. If your dealer is unable to give you the name of a servicer or if you need other assistance, call the following toll-free number for the name of an authorized servicer or authorized

parts distributor:

  1. 1-800-345-4494
  2. or you may write:
  3. CareCo, Service Department
  4. 415 W. Wabash Ave., P.O. Box 200
  5. Effingham, IL 62401

Proof of Purchase Date
It is the responsibility of the consumer to establish the original purchase date for warranty purposes. We recommend that a bill of sale, cancelled check, or some other appropriate payment record be kept for that purpose.

Frequently Asked Questions (FAQ):

Q: How often should I clean the air filters?
A: It is recommended to clean the air filters at least once a month to maintain efficient operation.

Q: Can I use this dehumidifier in a basement?
A: Yes, the HAMPTON BAY HB40-N dehumidifier is suitable for use in basements to control humidity levels.

Q: What should I do if the unit displays an error code?
A: Refer to the user manual for error code explanations and troubleshooting steps. If needed, contact customer support for assistance.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

HAMPTON BAY User Manuals

Related Manuals