Kaiwei Smart Music Boxing Target Instruction Manual

July 4, 2024
Kaiwei

Kaiwei Smart Music Boxing Target

Smart music boxing target Instruction Manual

PRODUCT

  1. beat position
  2. Type-C charging port
  3. Luminous region

Boxing target button operation instructions

Keys Long/Short function Illustrate

| Long press Short press| volume- Previous Song| Volume reduction When playing Bluetooth music, the song plays the previous one

| Long press Short press| volume+ Next Song| Volume Boost
When playing Bluetooth music, the song plays the next one
| Long press Short press| on/off Display switching| /
The content displayed on the display screen Is switched between he first and second screens
| long press for 1 second| |

  1. Press – • +. and O simultaneously for one second to enter the self-test program.
  2. Press any key to exit the self-test program or shut down and restirt to exit.
    Selflnspectlon process:
    a. The speoker plays back ground music or 81uetooth music;, and illl the light boards are Ut LI p
    b. The striking boord detects a striking signal, and the diseply screen displays the corresponding tag number. Thil corresponding light board lights Me :ill off Used for factory inspection

INSTALLATION

Installation Way1 :

  1. First, tear off the double-sided tape on the upper half of the EVA.
  2. The EVA paste is aligned on the back of the product.
  3. Tear off the double-sided tape on the lower half of the EVA sticker.
  4. Put it in place and stick it firmly on the wall

Installation Way2:

  1. Remove the shorter part of the Velcro tape and apply the Velcro Parallel to the back of the product.
  2. Apply the longer part of the Velcro to the back of the product,thenpeeloffthetapeandstickittothewall to ge ther with the product.

Troubleshooting

No.

| Symptoms| Cause Analysis| Method of exclusion
---|---|---|---

1

| No lights and no sound| The product is not powered on| Shortpress the switch

2

| No lights and no sound| Battery drain| Charge

3

| Lights flicker| low battery| Charge

4

| LONG PRESS THE SWITCH CANNOT TURN ON| The main chip capacitor is short of power due to long-term non-startup| PRESSANDHOLOTHESWIT(H
REPEATEDLY FOR 2·3 SECONDS

5

| Banging sound inside the device| Issued by the internal active stress structure| Normal phenomenon

PRECAUTIONS

  1. Pleasefixthisproducttoasolidandreliablesurface.Whenstriking,please be inthestrikingareaDonothitthecornerareatoavoidhandinjuryor device damage.
  2. This product is suitable for adults , children should be used under the guidance of adults
  3. Beginners should not hit too hard to avoid hand injuries. Pay attention to safety first during exercise, and leg and knee strikes are strictly prohibited.
  4. lt is strictly forbidden to hit the horn area
  5. lf the device cannot be turned on or is abnormal, please check whether the battery is too low and chargeit in time. The charging ti – me should not exceed 8 hours. It is recommended to charge once every 1-2 months if it is not used for a longtime.
  6. this product is not waterproof. When wiping the boxing target, use adryclothanddonotgetitwet
  7. Please keep the instruction manual for emergency need.

FCC Warning Statement

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:

  1. This device may not cause harmful interference.
  2. This device must accept any interference received, including interference that may cause undesired operation.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals