GUSROUND G2201-B Remote Control Car Instruction Manual

GUSROUND G2201-B Remote Control Car

Product Specifications

• Compliance : Part 15 of FCC Rules
• RF Exposure : General RF exposure requirement met
• Usage : Portable exposure condition without restriction

Product Usage Instructions

FCC Compliance
This device complies with part 15 of the FCC Rules. To ensure proper operation, please adhere to the following guidelines:

• Do not cause harmful interference.
• Accept any interference received, including undesired operation.

Avoid Interference
To prevent interference, consider the following suggestions:

• Reorient or relocate the receiving antenna if necessary.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a different circuit from the receiver’s.
• If needed, consult the dealer or a radio/TV technician for assistance.

RF Exposure
The device has been evaluated to meet general RF exposure requirements. It can be used in portable exposure conditions without restrictions.

CAUTION

1. Small parts.Keep out of reach of small children.
2. Please operate in an open field without any wave interference.
3. When transmitter is low in power, please stop and change batteries immediately.
4. On backout after the removal, please do not place discarded to avoid contamination sanitation.
5. Please store the car and the transmitter in a dry and cool environment.
6. Keep away from fire, hot or humid environment.
7. If car battery is wet,be sure to wipe and dry it completely to avoid any damage.

Product Configuration

Install Transmitter Batteries

1. Remove the battery cover by loosening the screw on the back of the transmitter with the included screwdriver.
2. Install 3×1.5V AA batteries (not included) in correct polarities.
3. Close the battery cover and tighten the screw. ****

Notice

1. When installing batteries,please be sure to match the polarities labeled on the battery holder.
2. Do not mix old and new batteries.
3. Do not mix different type of batteries.

Charge and Install Rechargeable Battery Pack

1. Connect the lithium-iron battery pack to the charger(Figure 1),note the charge light turns green.
   • Insert the charger into the outlet(Figure 2),note the charger light turns red-indicating it’s charging.
   • When charging is completed, charger light turns Green aGain.
2. Loosen the latches of the battery cover on the bottom of the car,then remove the battery cover.(Figure 3)
3. Connect the sockets of the rechargeable battery pack and the car in correct polarities, then insert the battery into the battery compartment. (Figure 4)
4. Close and secure the battery cover by tightening the latches. (Figure 5)

Charger/Battery Pack Circuit board Precautions

1. To prevent the lithium-iron battery pack from being charged over-voltage, which could lead to damage or explosion, the charger uses a voltage limit protection device.And to maintain the battery pack’s charging capacity and performance, we suggest not to charge it continuously for more than 24 hours.
2. The battery uses a low voltage and power over-discharge protection device. When the battery is over-discharged,a re-charged is required to active the battery again.It is recommended that you remove the battery and turn the switch to “OFF”position when the car is not being used.
3. The circuit board uses a overheating protection function. When the circuit board is overheated,the car will be disabled(not moving forward/backward) for 3-6 seconds before being restored.

Pre-Run Check
Cautions

1. Please plug the battery into the receiver and secured it on the battery tray. Then can turn on the power of remote controller.
2. Please remove batteries from the the model car or the remote controller when stop operating.
3. Please rematch the control frequency when the model car out of control.
4. Please remove the debris(dust.gravel,etc.)in the transmission structures.
5. Check if any screws are loose.
6. Check if any parts that requires apply lubricating oil. ****

Check every time before running

1. Transmitter (Switch)
   Open power switch on the transmitter.

2. Receiver
   Open power switch on after plug into the battery.

3. Check operation
   Operate the steering wheel to check if the front tires move correctly.
   The steering of the front tires is according the adjustment of the steering wheel on the remote controller.

4. Steering trim knob**** The steering of the front wheels is according the adjustment of steering wheel on the remote controller.
   When the steering trim knob is in the neutral position,please adjust the steering trim knob appropriately if the front wheels cannot walk straight.
   Adjust the steering trim knob appropriately if necessary while operating. ****

5. Check the throttle Pull the trigger of the remote controller back with your finger, and the model car will drive forward;pull the trigger forward with your finger once to brake,release it and wait for the trigger to return to the neutral position and then push it forward will drive backward.

6. Frequency matched procedure
   Turn on the switch of the remote control and the switch of the remote control car to automatically match the frequency.

Notice

1. Please plug the battery into the receiver and secured it on the battery tray. Then can turn on the power of remote controller.
2. Non-rechargeable batteries can not be charged.
3. Remove rechargable battery pack from car before charging.
4. Charge the battery under adult supervision.
5. Do not mix new and old batteries,or batteries of different types.
6. Remove batteries from car once they are exhausted.
7. Watch for short circuits at power terminals.
8. Touching the transmitter antenna while operating the car can affect the remote control distance;broken antennas should be handled by an adult.
9. This car is equipped with powerful driving forces, When moving at high speed,please do not try to break abruptly due to inertia.
10. When the car move slowly,it indicates power is low.Please recharge following charging instructions.

FCC Warning

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference
2. This device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Car Sticker Schematic

Frequently Asked Questions

Q: What should I do if I experience interference with the device?
A: If you encounter interference, try reorienting the antenna, increasing separation from other devices, or consulting a professional for assistance.

Q: Can I use the device in areas with high RF exposure?
A: The device is designed for portable exposure conditions and meets general RF exposure requirements, allowing for unrestricted use in such environments.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>