VALSTONE ENGINEERING 570 Polaris Ranger Light Guard Installation Guide
- June 29, 2024
- Valstone Engineering
Table of Contents
VALSTONE ENGINEERING 570 Polaris Ranger Light Guard
Light Removal
Remove the rear light to gain access to the tailgate check cable bolt nyloc
nut
Remove the Tailgate Check Cable Bolt
Remove the nut and bolt holding the tailgate stay cable, ensuring you retain the nut and pressed washer for use later
Fit Counterbored Spacer
Fit black counter-bored spacer onto the lower latch bolt. Ensure you do NOT
use the non-bored spacer also supplied.
Fit Small Bracket
Fit the supplied bracket over the lower latch bolt, ensuring to use the correct side matching the photo (reference the notch on the bracket lower section).
Ensure the Polaris pressed washer remains in place on the check cable bolt
hole.
Secure Internal Bracket
Replace the check cable bolt, using it to align the lower captive threaded hole of the bracket.
Reuse the nut that was removed earlier on the lower latch bolt and tighten to secure the bracket in place.
The check cable bolt can then be removed once again.
Replace Light
Replace the rear light using only the upper bolt to secure it at this point
Fit Spacer
Fit the supplied noncounterbored spacer on the lower light bolt hole as shown.
Fit Protective Foam
Fit foam edge to light guard.
This is optional but provides more protection to the vehicle at the contact
point of the guard.
Fit Guard
Fit the guard using the provided longer bolt for the lower light bolt hole, as well as the check cable bolt (re-fitting the check cable as necessary)
Use the slots on the guard to assist with alignment.
Fitting complete
Repeat the process on the opposite side, and enjoy your light guards
Customer Support
``Valstone Engineering – Where Precision Meets Expertise, Guided by Two
Brothers’ Passion.
sales@valstoneengineering.co.uk
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>