Creature Caster Lord Of Oppression Figure Of Dread And Despair Installation Guide
- June 29, 2024
- CREATURE CASTER
Table of Contents
Lord Of Oppression Figure Of Dread And Despair
“`html
Product Specifications:
- Model: Complete Model
- Components: 1-13
Product Usage Instructions:
Step One:
Assemble components 12, 1, 2, and 13 in the specified order.
Step Two:
Join components 1, 2, 13, 14, and 15 together as per the
assembly guide.
Step Three:
Attach component 6 to the assembly.
Step Four:
Connect components 1, 7, 8, 10, and 9 following the provided
instructions.
Step Five:
Secure components 11, 1, and 12 in place.
Final Step:
Complete the assembly by attaching components 3, 5, and 13.
Frequently Asked Questions (FAQ):
Q: How do I ensure all components are securely attached?
A: Make sure to follow the assembly guide closely and
double-check each connection point.
Q: What should I do if a component doesn’t fit properly?
A: Check for any obstructions or misalignments. If the issue
persists, refer to the troubleshooting section of the manual or
contact customer support.
“`
COMPLETE MODEL
ASSEMBLY GUIDE
This is a the complete guide to assembling the Lord of Oppression Miniature by
Creature Caster. To do this properly, be sure to lay out all of the pieces and
dry t all of the connections prior to using glue to afx them. Some pieces may
require a slight bit of cleaning, the removal of the tabs using a pair of
hobby snips, and cleaned up using a sharp hobby knife or le. If there is any
warping of the thinner pieces, applying heat via hot water or a hair-dryer
will be required. Simply heat up the piece, and pull it straight until it has
cooled.
COMPONENTS
6
11
1
8
7
12 10
9 2
4 3
5
13
STEP ONE
STEP TWO
12
1 2
13
14
15
STEP THREE
6
1
STEP FOUR
1
7
8
10
9
STEP FIVE 11
1
12
FINAL STEP
3
5
13
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>