Niczuk Beam Clamps with a Port ZNP Installation Guide
- June 29, 2024
- Niczuk
Table of Contents
Niczuk Beam Clamps with a Port ZNP
Product Specifications
- Product Name: Beam Clamp with Port ZNP
- Min. Shelf Thickness: 8 mm
- Max. Inclination: 14%
Product Usage Instructions
Installation of Beam Clamps with Port ZNP:
- Ensure the shelf thickness is at least 8 mm and the maximum inclination is not more than 14%.
- Place the clamp on the I-section ensuring the wedge is in contact with the flat side of the I-section.
- Use a hammer to tap the clamp and wedge together, ensuring they are in contact with the I-section.
- Insert the threaded rod into the port and secure it with a flat washer PD and a hexagonal nut 144 from the top and bottom to prevent movement.
Assembly of Steel Beam Clamp with Through-Hole (ZNP) on the I-Section:
Follow the same steps as mentioned above for installing beam clamps with port ZNP on an I-section.
FAQ
Q: Can pipe clamps be fixed to both normal and flat I-sections?
A: Yes, pipe clamps can be fixed to both normal I-sections (with an inclination of up to 14%) and flat ones with a shelf thickness of at least 8 mm.
Q: How should the threaded rod be secured in the port?
A: The threaded rod should be inserted into the port and secured against movement using a flat washer PD and a hexagonal nut 144 from both the top and bottom.
INSTALLATION INSTRUCTIONS FOR A BEAM CLAMPS WITH A PORT ZNP
-
Pay attention to the I-section type and shelf thickness
Pipe clamps may be fixed to normal I-sections (with the inclination of up to 14%) and flat ones with the shelf thickness of min. 8 mm. -
Put the clamp on the I-section
Insert the clamp wedge with a hand as far as possible. The wedge always has to be in contact with the flat side of the Isection.
-
Tap the clamp with a hammer
Tap the wedge to the I-section using a hammer . The wedge has to be in contact with I-section. -
Put the threaded rod in the port
Insert the threaded rod in the port. Secure it against moving, from the top and from the bottom, using a flat washer PD and a hexagonal nut 144.
THE ASSEMBLY OF A STEEL BEAM CLAMP WITH A THROUGH-HOLE (ZNP) ON THE I-SECTION
On-line orders www.niczuk.eu
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>