IKEA JETSTROM LED Ceiling Light Panel Instruction Manual
- June 28, 2024
- Ikea
Table of Contents
**IKEA JETSTROM LED Ceiling Light Panel Instruction Manual
**
Installation Instruction
Getting started
Connect your product to the mains or plug the power cable into the wall
socket.
Before you can use your light source you’ll need to pair it with a steering device
- Make sure that your light source is installed and the main power switch is turned on.
- Hold the steering device close to the light source you want to add (no more than 5 cm away).
- Press and hold the pairing button for at least 10 seconds. A red light will shine steadily on the steering device.
Your light source will begin to dim and finally flash one time to indicate that it has been successfully paired.
Up to 10 light sources can be paired with 1 steering device. Make sure to pair them one at a time. If the light sources are close to each other, disconnect those that have already been paired from the main power switch.
The colour temperature can be switched between 2200K (warm glow), 2700K (warm
white) and 4000K (cool white).
If you have the TRÅDFRI gateway or DIRIGERA hub Go to App Store or Google
Play and download the IKEA Home smart app. The app will take you through the
process of installing your product and other devices.
CAUTION:
DO NOT USE WITH STANDARD DIMMERS . This light source will not operate
properly when connected to a standard (incandescent) dimmer or dimming
control. Only controllable by IKEA Smart lighting products.
How to factory reset your product
If the product does not respond or if you want to un-pair the product from a
steering device you might have to make a factory reset. The product is forced
to factory reset by carefully inserting a paper clip end or similar in the
small hole (marked RESET) and apply a slight pressure.
IMPORTANT !
- The product is for indoor use only and can be used in temperatures ranging from 5 °C to 40 °C.
- Do not leave the product in direct sunlight or near any heat source, as it may overheat.
- The declared radio range between the unit and the steering device is measured in open air.
- Different building materials and placement of the units can affect the wireless connectivity range.
Care Instructions
Wipe clean with a damp cloth. Never use abrasive cleaners or chemical solvents
as this can damage the product.
Save these instructions for future use.
Tech nical data:
Type: L2207 JETSTRÖM
Input: 220-240 VAC, 50-60 Hz, 38 W
Max lumen output: 4600 lm
Radio range: 10 m in open air.
Operating frequency: 2405-2480 MHz
Output power: max 9 dBm
Manufacturer: IKEA of Sweden AB
Address: Box 702, SE-343 81 Älmhult, SWEDEN
RF EXPOSURE INFORMATION
According to RF exposure regulations, under normal operations the end user
shall refrain from being closer than 20 cm from the device.
This device complies with Part 15 of the FCC Rules/Innovation Science and
Economic Development Canada’s licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation of the device.
WARNING:
Any changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the quipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
License rights and limitations
NO RIGHTS OR LICENSES, EXPRESS OR IMPLIED, ARE GRANTED TO USE THIRDPARTY
DEVICES IN COMBINATION WITH THESE PRODUCTS IN A WIRELESS MESH NETWORK, OR TO
USE THIRDPARTY SERVICES TO ACCESS, MONITOR OR CONTROL THESE PRODUCTS IN A
WIRELESS MESH NEWORK VIA THE INTERNET OR ANOTHER EXTERNAL WIDE AREA NETWORK.
For use pursuant to U.S. Patent Nos.:
US 6,914,893
US 7,697,492
US 8,964,708
The crossed-out wheeled bin symbol indicates that the item should be disposed of separately from household waste. The item should be handed in for recycling in accordance with local environmental regulations for waste disposal. By separating a marked item from household waste, you will help reduce the volume of waste sent to incinerators or land-fill and minimize any potential negative impact on human health and the environment. For more information, please contact your IKEA store.
© Inter IKEA Systems B.V. 2023
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>