ledscom LC-L-287 WAIKA Wall Light Installation Guide

: June 28, 2024
: ledscom

Table of Contents

ledscom LC-L-287 WAIKA Wall Light
Safety instructions
Maintenance & care
Disposal
Assembly instructions
Documents / Resources

ledscom LC-L-287 WAIKA Wall Light

ledscom- C-L-287-WAIKA-Wall-Light

Please read these installation instructions carefully before installing this product and keep them for future reference.

Safety instructions

The product may only be installed by an authorized electrician.
Protection against electric shock must be ensured when working on electrical equipment.
Disconnect the building-side connecting cable from the power supply and secure it against being switched on again. To do this, trip the corresponding circuit breaker of the house installation.
Do not drill until you know the exact location of all power and water lines. Be careful not to damage them when drilling. Operate the product only when it is working properly.
In the event of a fault, do not touch the product.
Immediately turn off the product at an external switch. In the event of contact or continued operation in the event of a fault, there is a danger to life due to burns, electric shock or fire.
This is how you detect an error:
- the product does not work properly (e.g. cannot be switched on)
- the product smokes, crackles or smells burnt
- the product overheats (discoloration, also on adjacent surfaces)
Do not operate the product again until it has been repaired and checked exclusively by an authorized electrician!

Intended use

Please ensure that the product is only installed within its intended application (wall light, ceiling light) to ensure safe and effective use.

The product may:

only be operated with a voltage of 230V ~50Hz.
only be connected according to protection class I (one).
only be used in accordance with protection class IP20.
not be subjected to strong mechanical stresses.
not be changed or modified.
not be operated with an external dimmer
Operate only with GU10 bulbs with a maximum load of 60 watts
The product is not intended for operation by children. Ensure that children do not come to any harm with the product, e.g. by being burned on hot surfaces or by electric shock.
If the product is not used as intended, especially if moisture enters the product, there is a danger to life from burns, electric shock or fire.

Maintenance & care

The following environmental influences may have undesirable effects on the surface of the product:

high salt content in the air Detergent
other chemical substances (e.g. mold remover)
Protect the product by taking appropriate measures to avoid changes to the surface.
First disconnect the entire product from the power supply and allow it to cool down before carrying out any cleaning or maintenance work on the product.
Clean the product regularly – only with a slightly damp, soft and lint-free cloth.

Storage
The product must be stored in a dry place, protected from contamination and mechanical stress. After damp or dirty storage, the product may only be operated after a condition check by an authorized electrician.

Disposal

[European Union]
Do not dispose of the product in household waste! Products with this symbol must be disposed of in accordance with the Directive (WEEE, 2003/108) on waste electrical and electronic equipment via the local collection points for waste electrical equipment!

Assembly instructions

Disconnect the building-side connecting cable from the power supply and secure it against being switched on again. To do this, trip the corresponding circuit breaker of the house installation.
Remove the mounting plate (1) by loosening the screws (2). Then carefully lay the light on its side so that it cannot be damaged.
Drill holes in the mounting base and insert two dowels there. The positioning of the holes should correspond to those of the screw holes (3) on the mounting plate. Make sure that the dowels are flush with the substrate.
Then fix the mounting plate (1) to the mounting base with the aid of two screws.
Connect the wires of the cable according to “Figure 2”.
Place the light back on the mounting plate (1). Then retighten the screws (2) to fix the light to the mounting plate. The installation is now complete.
Mounting plate
Screws
Screw holes