WILDFIRE OUTDOOR LIVING 2024 30 Inch Ranch Pro Grill User Guide

: June 28, 2024
: WILDFIRE OUTDOOR LIVING

Table of Contents

WILDFIRE OUTDOOR LIVING 2024 30 Inch Ranch Pro Grill
Read User Manual Online (PDF format)
Download This Manual (PDF format)

WILDFIRE OUTDOOR LIVING 2024 30 Inch Ranch Pro Grill

NATURAL GAS & LIQUID PROPANE CONVERSION GUIDE
3011 • 3611 • 4211 RANCH PRO GRILL

You will also need the following tools:

Phillips head screwdriver
1/ 4″ socket
Phillips head right angle ratchet (optional}
Adjustable wrench

Your conversion kit will arrive with all the parts needed to convert your natural gas grill to liquid propane (Fig 1.1) or natural gas (Fig 1.4). Included

Gas specific regulator
Natural gas or liquid propane conversion orifices
Infrared conversion orifice

The conversion kit is made to work across Wildfire’s entire collection, for this application we will need 2-4 of the conversion orifices (Fig 1.2}, the gas specific regulator, and the infrared conversion orifice Fig 1.3.

Natural Gas (NG) Conversion Kit Part #’s

No.| Description| Qty| Part No.
1| NG Conversion| 1| 10-00020-NG Regulator
2| Mack Burner Orifice| 4| 02-010456
3| Back Burner| 1| 02-01054
Liquid Propane (LP) Conversion Kit Part #’s

No.| Description| Qty| Part No.
| LP Conversion| | 10-00023-LP Regulator
2| Main Burner Orifice| 4| 02-01045
3| Back Burner| | 02-01053

Start by removing all the cooking grates and flame tamers, to gain access to the burners.
Remove the brackets (see STEP 2} securing the burners in place shown in figure, by unscrewing the two Phillips head screws.
Once all burner brackets have been removed you will then need to remove the cotter pins from burners located under the grill.
This is done by lifting up the end furthest from the front and gently pulling forward.
If you meet any resistance stop and try a slightly different angle.
With the burners removed you may now remove the old gas orifices by using a 1 / 4″ socket. Repeat this process for each burner.
After removing the old gas orifices, the new orifices provided (Fig 1.2) in the conversion kit can be installed by carefully using the socket to hold the orifice and screwing it in.
Repeat this process on all burners before.
To convert the infrared burner (back burner) orifice, simply unscrew the small panel shown in STEP 4 to the rear of the grill Ausing a Phillips head screwdriver.
With the panel removed you will be able to unscrew the infrared burner orifice from it’s mount by removing the bolt.
Simply unscrew the old infrared burner orifice and screw in the new provided orifice. (Fig 1.3) Once the new orifice is installed, you may reverse the last two steps to reinstall the fitting.
With everything reassembled remove the original regulator at the rear of the grill and install the provided appropriate regulator from the conversion kit.